Dot view case question

Search This thread

MsEvyLynch

Senior Member
Jan 25, 2013
239
121
Stupid question but I like the dot view case but I like the metal finish better. Do you think if I were to cut the back of the case off leaving the binding on and just tape the binding to the back. Thus only having the front of the case leaving the back empty.

Do you think that could work?

I'm debating weather to risk doing that on my $30 case.
 

BygSii

Senior Member
Jan 27, 2013
173
20
There is a little tab in the middle that has a piece of metal in it to help the case snap back onto the screen. You would have to use that tab to your advantage to glue that to your phone to prevent any sliding. Remember, the dot view case has to be on perfect for it to work. Just wait it out. Someone will make a clear back version of it and sell it on Amazon or eBay.
 

1ManWolfePack

Senior Member
Jul 11, 2012
2,384
1,758
The guy at my Vzw store stole the display model case and the back is all cut up for the security sensor thingie. It works fine.

So yes.

Sent from my HTC6525LVW
 

Rushing

Senior Member
Jan 13, 2012
2,297
2,893
Los Angeles
Also there is a place where no questions are stupid lol and that is in the q and a. Good luck

Sent from my HTC6525LVW using XDA Premium 4 mobile app
 

85gallon

Senior Member
Do you think if I were to cut the back of the case off leaving the binding on and just tape the binding to the back.

WOW!!!

Here you go......


duct-tape.jpg
 
  • Like
Reactions: 1ManWolfePack

Top Liked Posts