flashed this over the Tranquil Rom, against advice... I scored higher than 30000 on Antutu Benchmark!!!
Set at 1998mhz top and 384mhz bottom ,
fiops Scheduler
Badass Governor
I could not get it to boot on tranquil obone booted fine how did you get it to boot?
Sent from my HTCONE using xda app-developers app
I have flashed silence kernel on ViperOne 3.5, first 2 days phone was working flawlessly, but then battery started draining fast. At night, it goes from 100 to 80-85, even when wifi/data is off and power saving mode is on. I don't have any idea why it started drain so fast. CPU governor is set to "ondemand", and I/0 scheduler is set to "fiops", any suggestions?
When i charge to 100%, in next 30-40 minutes it goes to 90-93(when i'm not using phone), then stays there for a short time and drains normally. After some time, for example at 70%, it does same thing again. Tried underclocking CPU to 1566, changed governor to "badass", almost same..
If you need more information, just tell me what to provide))
Whoa necrobump...back from the deadSeems an update to lollipop is due. New download link in the op
Seems an update to lollipop is due. New download link in the op
I'm running the new kernel cause I love dt2w. One thing is, it doesn't show the lock screen on wake after a double tap or swipe or pressing the power button just a dark screen. I can still swipe up and the screen comes on. I can turn off screen lock and the screen turns on after wake methods but I'd rather not.
EDIT/ADD: Scratch that, it seems to be working now. Like it needed to settle in or me turning lock screen on and off a couple times did the trick. Awesome! Thank you.
DOUBLE EDIT: it still does what I earlier described.
Sent from my HTCONE using XDA Free mobile app
Should be on by default if not use trickster mod from the play store it's free and easy to useCan somebody plz tell me how to enable dt2w on stock lollipop 5.0.2 using this kernel..
I used xposed modules to do that on 4.4 but now I hv no idea..Is it enabled by default?
CHANGELOG
Release 2/13/15
update to Lollipop
Release-2 (1/20/14)
sched: Reset rq->next_interval before going idle
reduce regulator constraints to allow undervolting to 800
add sysfs vdd
switch do_fsync() to fget_light()
mm: remove swap token code
readahead: make context readahead more conservative
reduce packet delay to try andreduce wakelocks
Release 1 (1/12/14)
reduce l2 cache
and moar changes to sound control
moar changes to sound control
more changes to sound control
update sound control
soundcontrol
update defconfig
sched: reinitialize rq->next_balance when a CPU is hot-added
Make word-at-a-time a truly generic interface
MEM: allow lowmem to be non contiguous and mixed
ARM: dcache: select DCACHE_WORD_ACCESS for little-endian ARMv6+ CPUs
oc slimbus (thanks poondog)[better audio]
optimized sq root algorithm
lower l2 cache for OC freq
change load average computation in rq stats
manage online cpus
address issue where cpus forget their clock speeds
add CPalmer's thermal driver
add BadAss CPU gov
remove some perflock code
add CPU OC option (coming soon)
lib/lzo: huge LZO decompression speedup on ARM by using unaligned access
add vr sio zen schedulers
change clocks once again to better use new step
change clocks once again
change clocks once again
lower l2 cache 1 more freq
lower l2 cache 1 freq
clock adjustment
further boost l2 chache
boost gpu clock (3d)
boost gpu clock
further boost l2 cache
fix race that cause writeback hung
add bb mod from tbalden
boost l2 cache
add dynamic fsync
increase gpu bandwidth
[patch] sched: minimalist select_idle_sibling() bouncing cow syndrome… …
increase read ahead value
update topology driver
sched: Micro-optimize the smart wake-affine logic
sched: Implement smarter wake-affine logic
Fix occasional slow sync(1)
tweak load average
LIB: ARM: use generic strnlen_user and strncpy_from_user
LIB: ARM: use generic strnlen_user and strncpy_from_user
makefile addition
fix possible memmory leak cfg80211
make vfs pressure configurable
sched/nohz: Fix rq->cpu_load calculations some more
sched/nohz: Fix rq->cpu_load[] calculations
sched: Fix nohz_idle_balance()
sched: Change rq->nr_running to unsigned int
sched.fair improve the group logic
Autogroup patch group by current user android UID
patch from caf
Support cpu hotplug in no PM cases
sched: fix init NOHZ_IDLE flag
sched: Improve scalability via 'CPU buddies'
ARM RWSEM algorithm
tweak writeback ratios
optimize slack
allow pipe compiling
ARM: net: JIT compiler for packet filters enabled by default
add some makefile flags
Enable UNALIGNED_ACCESS for the new LZO algorithm to use
update LZO
glibc memcpy and stringcpy
avoid depleting of entropy pool
increase random number generator rate
vfp optimization
add s2w,dt2w with pocket detection and custom config
If you could make a 4.4.x kernel, That would be great, as people need one for 4.4 instead of 4.3, as to date there are no 4.4 kernels out there, there are dozens of 4.3 kernels on the other hand. You would be greatly thanked if you could make a 4.4 kernel.
Yes, echo 1 /sys/kernel/fast_charge/forced_fast_charge
Sent from my HTCONE
There were 4.4 kernels before any 4.3 kernels came out lolIf you could make a 4.4.x kernel, That would be great, as people need one for 4.4 instead of 4.3, as to date there are no 4.4 kernels out there, there are dozens of 4.3 kernels on the other hand. You would be greatly thanked if you could make a 4.4 kernel.