[Q] Help! Flashing .kdz stopped working after TWRP

So, I've been using the .kdz method successfully to flash my D802 several times before, no issues at all.

I'm on stock 4.2.2, rooted and I installed TWRP, everything is working fine, but I decided to move on to 4.4.2 (stock) using the .kdz flash method and I just can't get it to work anymore... I've tried several times but I just get stuck on 49% all the time...

The flash tool says this:

13:35:04 : #################################################
13:35:04 : Indirect Internal / PC to Phone send end
13:35:24 : wParam : 13, lParam = 46
13:35:44 : wParam : 13, lParam = 47
13:36:06 : wParam : 100, lParam = 3146241
13:36:06 : MODEL DLL Event : (100, 3146241)
13:36:06 : Step : TYPE_WPARAM_UPGRADE_ERROR
13:36:06 : CleanModelDll() : Free Model.dll
13:36:06 : _DetachDLL Call
13:36:11 : _DetachDLL Call End
13:36:11 : Page_Error ºÎºÐÀÔ´Ï´Ù
13:36:11 : ¿©±â´Â Retry ºÎºÐÀÔ´Ï´Ù

Any ideas?

I think I have really messed things up now...

I downloaded Cloudyfa's 2.4 ROM and stock KK kernel and installed using TWRP. Phone was working fine, then I used the .kdz method to try and flash again (stock KK ROM) and this time the flash completed fine. Phone started up but had loads of process stopping, so I did a factory reset and now all I get is the little android with the cube spinning. I can flash any .kdz again but as soon as the phone reboots, the android is there with the cube spinning...

Have I bricked it irreversably?


Never mind, got this working again now.... Flashed a JB .kdz and then up to KK .kdz and its all good