[17/03/2013] [JB] [4.1.2] Pixeldroid Jelly Bean V8.0[AOKP] [BeatsAudio] [720p]

-pixelfreak- · Feb 18, 2013

re

triakom said:
I tried this version and the previos one and always stuck at the aokp horse. No chance to start. The instalation is ok.
Nand/DataOnEXT /SWAP.

for this post no support. please read the first post

pixelfreak

hachi-roku · Feb 18, 2013

allroad76 said:
that program is the first screenshoot, where are the settings of the CPU? How do you install a different font?

thanks

@allroad76
I use demon controller to change cpu frequency and use font changer to change font

hachi-roku · Feb 18, 2013

-pixelfreak- said:
@hachi-roku
the rom have no mistake for NandOnEXT instal. i have test from yesterday eight times and no problem. i think the problem is the HD2 and sd card configuration from other users. sorry for this user. i can test only on my EU and Tmous and all works good

CLK Instal i have not test with V2.4. if installes a user this he make a feadback from CLK instal

many thanks

Pixelfreak

For me instalation with nand and data on ext ok without initrd patcher . Bootloader CLK.

-pixelfreak- · Feb 18, 2013

re

hachi-roku said:
For me instalation with nand and data on ext ok without initrd patcher . Bootloader CLK.

i have read my scripts and this have no mistake inside.

pixelfreak

hummy15 · Feb 18, 2013

The only way i have been able to boot this rom after flashing,, is to flash another rom soon after it and then boot from 2nd rom. I think there is a problem with haret or init files.I may be wrong

bbot3k · Feb 19, 2013

hachi-roku said:
Press power button and select reboot then recovery.

Sent from my PIXELDROID HD2 using xda premium

---------- Post added at 12:55 PM ---------- Previous post was at 12:45 PM ----------

Just press power button select reboot then recovery.
If in off state press power after that hold home button

Sent from my PIXELDROID HD2 using xda premium

when i hold power button and reboot into recovery, it just boots the nativesd folder and back to regular. my goal is to get to the fix permission part after i executed superclean.sh.

---------- Post added at 03:33 AM ---------- Previous post was at 03:28 AM ----------

-pixelfreak- said:
- hold the power button lonk and go back to recovery
- you can meke self a vibration via romcontrol/Vibrations
- the toggle sttings romcontrol/switches/activ switches

pixelfreak

when reboot into magldr, i go to 10. services > 1. boot settings > 3. AD SD Dir > 4EXT > 2. Boot AD SD

SD Kernel open failed.

fOxunO · Feb 19, 2013

hummy15 said:
The only way i have been able to boot this rom after flashing,, is to flash another rom soon after it and then boot from 2nd rom. I think there is a problem with haret or init files.I may be wrong

if you are using nativeSD , pls check clrlrd and haret , usually is bigger than other rom.
this is same with rom from anurag , so I replace clrcrd and haret with small one.

hachi-roku · Feb 19, 2013

Re: [17/02/2013] [JB] [4.1.2] Pixeldroid Jelly Bean V2.4[AOKP] [BeatsAudio] [720p]

bbot3k said:
when i hold power button and reboot into recovery, it just boots the nativesd folder and back to regular. my goal is to get to the fix permission part after i executed superclean.sh.

---------- Post added at 03:33 AM ---------- Previous post was at 03:28 AM ----------

when reboot into magldr, i go to 10. services > 1. boot settings > 3. AD SD Dir > 4EXT > 2. Boot AD SD

SD Kernel open failed.

Hi
i use rom manager to fix permision
If you run on nsd i think fix permision from 4ext recovery not work

Sent from my PIXELDROID HD2 using xda premium

bbot3k · Feb 19, 2013

Re: [17/02/2013] [JB] [4.1.2] Pixeldroid Jelly Bean V2.4[AOKP] [BeatsAudio] [720p]

thanks. also I found a bug with alarmdroid when testing alarm with test button, after turning off test audio comes back on and WILL NOT stop haha had to reboot twice

sent from my hd2 breh

Kenneth914 · Feb 19, 2013

thanks 4 sharing the rom
i installed the rom in NAND yesterday
the rom is very smooth， everything works great
today i reboot the phone once，it took a long time
and i lost all my apps in data somehow，it's kind of strange
thanks again 4 ur great work

powerofthink · Feb 19, 2013

which one do we prefer? ppp or Rmnet connection..

i have hd2 EU version with magldr. i have installed this rom chosing Rmnet. wifi connection seems a little bit slow.
perhaps i might have chosen ppp connection during rom installation... which one do you prefer.... or now any chance to change connection type from rmnet to ppp...

-pixelfreak- · Feb 19, 2013

re

powerofthink said:
which one do we prefer? ppp or Rmnet connection..

i have hd2 EU version with magldr. i have installed this rom chosing Rmnet. wifi connection seems a little bit slow.
perhaps i might have chosen ppp connection during rom installation... which one do you prefer.... or now any chance to change connection type from rmnet to ppp...

magldr works better with rmnet

pixelfreak

-pixelfreak- · Feb 19, 2013

fOxunO said:
if you are using nativeSD , pls check clrlrd and haret , usually is bigger than other rom.
this is same with rom from anurag , so I replace clrcrd and haret with small one.

i have not change the clrcrd and haret from 1.0-2.4

this is not the problem

pixelfreak

burga_b · Feb 19, 2013

you didn't changed but the viruses did. I had to replace those two files, too. By the way, very good rom (AnTuTu: 3874) but sometimes is not very friendly with battery. Even in standby, sometimes I have - 80 - 100 mA consumption (wifi off, screen off). So, not all the times, but sometimes. Anyway, you made a great ROM!

fOxunO · Feb 19, 2013

-pixelfreak- said:
i have not change the clrcrd and haret from 1.0-2.4

this is not the problem

pixelfreak

I'll start your ROM directly to 2.4

your clrcrd 76KB , replaced with clrcrd 4KB
your haret 235KB , replaced with haret 159KB

I don't know why , if not replaced , after click haret get stuck.

for me , your ROM is faster for browsing

hachi-roku · Feb 19, 2013

burga_b said:
you didn't changed but the viruses did. I had to replace those two files, too. By the way, very good rom (AnTuTu: 3874) but sometimes is not very friendly with battery. Even in standby, sometimes I have - 80 - 100 mA consumption (wifi off, screen off). So, not all the times, but sometimes. Anyway, you made a great ROM!

maybe some app running in background, my phone in standby mode is around -8 to -15 ma with wifi standby,

abced123 · Feb 19, 2013

hachi-roku said:
maybe some app running in background, my phone in standby mode is around -8 to -15 ma with wifi standby,

how do you measure the mA of the device 's power consumption?

powerofthink · Feb 19, 2013

it is being tested today.

- i am installing some app. for example "google earth" by way of "blackmart". it didn't run.
and after that i uninstalled it. But my phone started to warm up, and screen has frozen. i needed to put off battery.

- in addition, i installed "imediashare premium". after installation and after uninstall ,it caused same thing(warm up and reboot itself).

- Sometimes in opera software (especially on xda webpage, after 4-5 pages with different topic), opera crashes and stop to run.

- i can't update "smanager" app. whrn i try to update it says "different signature".

Today, i will continue to test it..(26gb Fat32, 2gb ext4, 600mb swap. all of them primary)

---------- Post added at 01:49 PM ---------- Previous post was at 01:44 PM ----------

abced123 said:
how do you measure the mA of the device 's power consumption?

You can use "battery monitor" widget. you can find it blackmart or market.

hachi-roku · Feb 19, 2013

abced123 said:
how do you measure the mA of the device 's power consumption?

you can search third party app from market like battery monitor. You need fully charge and fully discharge at least 3 cycle, after that your battery is accurate.

hachi-roku · Feb 19, 2013

powerofthink said:
it is being tested today.

- i am installing some app. for example "google earth" by way of "blackmart". it didn't run.
and after that i uninstalled it. But my phone started to warm up, and screen has frozen. i needed to put off battery.

- in addition, i installed "imediashare premium". after installation and after uninstall ,it caused same thing(warm up and reboot itself).

- Sometimes in opera software (especially on xda webpage, after 4-5 pages with different topic), opera crashes and stop to run.

- i can't update "smanager" app. whrn i try to update it says "different signature".

Today, i will continue to test it..(26gb Fat32, 2gb ext4, 600mb swap. all of them primary)

---------- Post added at 01:49 PM ---------- Previous post was at 01:44 PM ----------

You can use "battery monitor" widget. you can find it blackmart or market.

Maybe you can use this method to uninstall some app.
1. force stop
2. Clear data (if any)
3. Clear cache (if any)
4. Uninstall

[17/03/2013] [JB] [4.1.2] Pixeldroid Jelly Bean V8.0[AOKP] [BeatsAudio] [720p]

Senior Member

Senior Member

Senior Member

Senior Member

Senior Member

Senior Member

Senior Member

Senior Member

Senior Member

Member

Senior Member

Senior Member

Senior Member

Senior Member

Senior Member

Senior Member

Attachments

Senior Member

Senior Member

Senior Member

Senior Member

Attachments

Similar threads

Top Liked Posts