Thank you @navneetasnavi for helping me out.The problem was that I always used kernel from stock recovery.Thanks a lot.
Last edited:
[Resolved] [Q]Not able to port COT Recovery to my MT6572 device.
- Thread starter nightwalker
- Start date
Yes,please tell me how did you port cot?I ported it successfully for my device XOLO A600Can i help u ?
do follow the procedure by the image provided by carliv in the tutorial. donot read the procedure.
make sure few things like this ..
1. recovery.fstab should be from working cwm image.
2 init.rc should be edited properly.
3. and most importand the kernel should be replaced by the one which u get inside boot.image after unpacking it using michfood's unpack-repack tool to that provided in cot recovery.
then repack the cot recovery . flash it and enjoy..
And check my ported cot recovery here >>>
http://xdaforums.com/showthread.php?p=53564962#post53564962
Can you explain what changes I need to do in init.rc?I am not able to figure it out!Sure let me know if it works
mounting points and there would b a line with a number something like c303 u need to make that exactly similer to as it is in your cwm init.rc.
In my cwm init.rc do I have to change my mkdir/boot etc similar to cwm in the cot init.rc?
Leave everything as it is in init.rc of urs just change that c303 to same as in cwm . it might b c301 after that save and close .
Last edited:
your most welcome
and dont just say thanks press it
---------- Post added at 07:10 PM ---------- Previous post was at 07:07 PM ----------
Most welcome bro
Today,I have finished my thanks.Tomorrow surelyyour most welcome
and dont just say thanks press it
---------- Post added at 07:10 PM ---------- Previous post was at 07:07 PM ----------
Most welcome bro
That is totally fine
I helped u to make development better not only for thanks it is just a complimentary Enjoy .
Similar threads
- Sticky
Top Liked Posts
-
There are no posts matching your filters.
-
11
do follow the procedure by the image provided by carliv in the tutorial. donot read the procedure.
make sure few things like this ..
1. recovery.fstab should be from working cwm image.
2 init.rc should be edited properly.
3. and most importand the kernel should be replaced by the one which u get inside boot.image after unpacking it using michfood's unpack-repack tool to that provided in cot recovery.
then repack the cot recovery . flash it and enjoy..
And check my ported cot recovery here >>>
http://xdaforums.com/showthread.php?p=53564962#post5356496211
Today,I have finished my thanks.Tomorrow surelyyour most welcome
and dont just say thanks press it
---------- Post added at 07:10 PM ---------- Previous post was at 07:07 PM ----------
Most welcome bro
1
That is totally fine I helped u to make development better not only for thanks it is just a complimentary
Enjoy .
