Summary:
I wanted a wireless charger that's upright but I purchased my nexus wireless charger before any 3rd party options became available (the cheaper AirDock for example). I also don't have access to 3D printers, so I can't go that route. So I decided to go the frankenstein route, and this is what I came up with. This is a dead simple DIY project, but it turned out really nice, so I thought I'd share it.
Parts:
17mm to AMPs:
http://www.ebay.com/itm/Arkon-SP-SB...483?pt=GPS_Holders_Mounts&hash=item53eba42fdb
17mm ball mount:
http://www.amazon.com/ARKON-GN014-G...id=1390011213&sr=8-5&keywords=17mm+ball+mount
Optional Double Sided Tape:
http://www.amazon.com/Scotch-Mounti...=1390011251&sr=8-4&keywords=double+sided+tape
I don't know if i've used up the stickiness of the nexus charger, but it wont stick on it's own. So I got some double sided tape and stuck them together that way.
I'm only using the magnets on the charger to keep the phone from sliding, and sadly, even extremely thin cases like diztronic interferes with the magnets too much.
There's a thread somewhere about the "thinest case" from China, and that one allows the magnets to work. I've also ordered some slickwraps skins, and I assume those would work as well.
I wanted a wireless charger that's upright but I purchased my nexus wireless charger before any 3rd party options became available (the cheaper AirDock for example). I also don't have access to 3D printers, so I can't go that route. So I decided to go the frankenstein route, and this is what I came up with. This is a dead simple DIY project, but it turned out really nice, so I thought I'd share it.
Parts:
17mm to AMPs:
http://www.ebay.com/itm/Arkon-SP-SB...483?pt=GPS_Holders_Mounts&hash=item53eba42fdb
17mm ball mount:
http://www.amazon.com/ARKON-GN014-G...id=1390011213&sr=8-5&keywords=17mm+ball+mount
Optional Double Sided Tape:
http://www.amazon.com/Scotch-Mounti...=1390011251&sr=8-4&keywords=double+sided+tape
I don't know if i've used up the stickiness of the nexus charger, but it wont stick on it's own. So I got some double sided tape and stuck them together that way.
I'm only using the magnets on the charger to keep the phone from sliding, and sadly, even extremely thin cases like diztronic interferes with the magnets too much.
There's a thread somewhere about the "thinest case" from China, and that one allows the magnets to work. I've also ordered some slickwraps skins, and I assume those would work as well.