You're welcome
Nice to know that you finally solved the problem
Shut down your phone, Hold in the 'Volume Down' button on the side of your phone while briefly pressing the power button to turn the phone on. Keep holding in the 'Volume Down' button until a tri colour screen appears and then you can let go. This is the Bootloader screen and if you look at the second line down it will tell you what version your SPL is.hi. i have a question regarding the HSPL...
under your second step: Flash HSPL, i dont understand this sentence > "IMPORTANT: To install/uninstall this HSPL3 there must be any SPL version from this list on your device:
SPL 1.42.0000, SPL 1.62.0000, SPL 1.66.0000, SPL 2.07.0000, SPL 2.08.0000, SPL 2.10.000"
how can I check my SPL version?
thanks and cheer~
You're welcome im glad it went smoothly for youThanks for this tutorial!
Made it easy and straight forward!
I got tired of O2 delaying or even not releasing rom updates when other providers do, so I HSPL my device and installed the HTC official rom, quick, easy and with no problems. Many thanks!
No just flash the rom and it will replace the radio. If you flash via sd card it will remove hspl also and change back to stock spl. If you can't flash via sd, flash via usb and then run hspl and change spl back to the correct stock spl.This thread is great!
I have one question regarding uninstallation:
Since I've upgradede ROM to 2.15.50 and put a custom rom, now I want to go back to stock rom, but from the official rom page I've downloaded this:
RUU_Leo_HTC_WWE_EastEurope_1.66.479.2_Radio_CRC_Signed_15.32.50.07U_2.07.51.22_2_Ship
Sine that was my stock rom and the radio was 2.07.51, do I need to perform task 29 first then radio change then this rom or?
Thanks in advance,
A
Can you still boot into bootloader mode? If so then try going back to stock rom and try again.Hello, i hope somebody can give me a hint. I got my HD2 back from repair today, and wanted to get my android back on, i did all like i did before, but now i,m stuck in MAGLDR 1.12, only i cant make any selections, cant move up or down with volume like before. Cant flash anything, because i cant get into bootloader, should i start to use my HD2 as an paper wight? Any help will be apriciated...
Regards
Peter, sweden but danish....
Hi! I want to install Android on my HD2 but it was said to me, that first I need to install radio at least 2.08. for this I need HardSPL. From your Thread I briefly understend how to make it so I wanna try it. Just to be sure if something goes wrong:if I will make factory reset, will it help and will make my phone as a "brand new" or with installing HardSPL and radio I will change it completely? I saw there is some way how to uninstall HardSPL just didn't understand it well... So I want to have some "backdoor" just in case.
Thank you for answer!
Hello, I've got HSPL 2.08 but when I try to flash the radio Active Sync drops when the phone reboots into boot loader. This causes the radio installer to give an error, saying that the device can no longer communicate. Any ideas? Thanks!
Hello, I've got HSPL 2.08 but when I try to flash the radio Active Sync drops when the phone reboots into boot loader. This causes the radio installer to give an error, saying that the device can no longer communicate. Any ideas? Thanks!
After installing HardSPL did you flash the official rom via sd card or via usb cable?hello i installed the hard spl and confirmed it in bootloader screen then it hanged in the splash screen in official roam then i installed the radio and custom roam via micros sd now the custom roam NRZ hangs at the splash screen .
what did i do wrong help plz
After installing HardSPL did you flash the official rom via sd card or via usb cable?
Can you confirm that you still have HardSPL from the bootloader screen.
Does it just stay on the white screen and not go any further?
Mark.
Hi Could someone help me please!?
I need to send my HD2 back for warranty reasons (ghost screen problems) and therefore need to restore the original SPL and factory ROM before sending it, I have SPL-2.08.HSPL (CotullaHSPL) installed, however when I follow the instructions on page one of this thread and try to restore a factory ROM from the micro SD card, I boot into the bootloader screen and it just sits there with Serial showing towards the bottom of the screen and does nothing - no on screen instructions to follow etc. - Any help is much appreciated as it has to go back tomorrow and I think they'll void the warranty if I don't restore it to original ROM etc.
Many thanks
Hi, I'm new to the HD2 and ROMs. I too got one just before Xmas, and to be fair its been a pile of ****. Mines a Voda and Rom 1.43.405.1 (70124) WWE and Radio 2.04.50.22_2
Is this a special Voda ROM?
I want to install the WWE 1.66.405 Official ROM. Using this forum I managed to download it, using a non-Voda serial num.
What I want to do is to install this ROM (hoping my reception and SMS will then be better) but as Voda wont support it, I need to be able to return it back to 1.43 if I need service etc.
Can anyone advise what I need to do to both upgrade to 1.66 and be able to regress to 1.43 if needed?
Thanks
Am i right in thinking if i just do the standard flash it'll only overwrite the bootloader with 3.03 and i'll be stuck there yes ?
(HD2 originally on T-Mobile UK
My pleasure bud . I haven't tried this so can't be 100% certain, but if you just want the latest 3.14 rom you can always just flash the rom normally using hspl
Need help, i want to flash stock RUU_Leo_S_HTC_WWE_3.14.405.2_Radio_15.42.50.11U_2.15.50.14_LEO_S_Ship.exe , and i've got error message:
ERROR [294] : INVALID VENDER ID
Thid Update Utility cannot be used for your PDA phone. Please check your update utility.
HDa6-PC:45567-HUEbc5687PC:455670
Click 'Exit' to Quit
What should i do?
ON Bootloader screen i have
PB81100 HX-BC
SPL-1.42.0000 XE
MicroP(LED) 0x05
MicroP(TOUCH) 0x40
Please Help.