Failed RUU flashing, need help

Search This thread
hi,

I am a bit confused right now... i wanted to go back to stock so i flashed an indian ruu without researching in detail. I got few vibrations while flashing radio. tried it few times, same result. stuck in HTC logo with 4 triangles in corners.

then i found Bortak's thread. I was S-Off so did whatever mentioned on the post. but it didn't work. then I thought changing the ruu.

Downloaded RUU_Bravo_Froyo_HTC_WWE_2_29_405_5_Radio_32_49_00_32U_5_11_05_27_release_159811_signed.

flashed it, signature or verification problem. but now my device showed S-ON. and still the same results occur.

tried making goldcard. but, device is not detected on adb. but shown in device manager as My HTC under adb interface.

Now, I am running out of ideas.

plz help me. any suggestions would be appreciated.

Thanks,
Bibek
 

eddiehk6

Senior Member
Dec 18, 2010
1,506
666
London
Try the 2.3.3 GB RUU, you shouldn't even need a goldcard for this

Write out any error messages here if it fails to flash
 

eddiehk6

Senior Member
Dec 18, 2010
1,506
666
London
Tried it. But it says customer id error 131.

I thought 2.3.3 GB RUU shouldn't need to do a CID check, so should work without a goldcard

Are you sure you're flashing the correct RUU?

http://www.htcdev.com/process/legal_download/152

If it doesn't work normally, try PB99IMG.zip method as in Bortak's thread [7]


same with my problem. Failed on radio v 2.

Your problem is different. Unfortunately yours is a radio brick, which is the worst kind. Even flashing an RUU is unlikely to fix it :(
 
  • Like
Reactions: bibekdwa

Top Liked Posts