So i was trying to flash CM 11 onto my Razr HD following the instructions on this thread:
http://xdaforums.com/showthread.php?t=2518701&highlight=boot+loop
However, after flashing and everything, my phone ends up in a bootloop... I'm on 4.4.2, 183.46.10XT926, kernel 3.4.42 and an unlocked bootloader
Any help?
I know you stated you followed the directions, but just in case, this is what I do:
1. Boot into TWRP
2. Wipe cache, dalvik cache, data and system
3. Install CM11.
4. Install GAPPS
5. Wipe cache and dalvik (from the Install screen)
6. Reboot and profit.
If this still doesn't work for you, you might have a corrupted download for CM11 and/or GAPPS, so try downloading them again and make SURE you are using the correct CM11 image.
If you are getting them from epinter, then make sure you choose the correct one. There are a LOT of ROM images there (for XT925, for CM10 for JB-based phones, CM11 xt926 I believe is for JB based phones, you want the CM11 with msm9690 in the file name).
I get mine from here ->
http://download.cyanogenmod.com/?device=moto_msm8960
Also, make sure you have the correct TWRP installed (2.7.1.0) that is KK based. Do NOT use earlier versions which are based off of JB.
You can also use CWM recovery, but make sure it's 6.0.4.9. Anything else is for JB-based phones that haven't been upgraded to KK.