Been looking all over and can't really find any info (even in the vibrant bible or dev section) about how to use HAC mode. I found the following instructions on how to set my volume at max (100) using HAC mode, but I am specifically wanting to know if and how to save it at that setting, since when I reboot my phone it resets... also is there anyway to increase the "in call" volume through the ear phone to max? if so, how? Thanks
Dialer: *#*#197328640#*#*
[5] AUDIO
[1] HANDSET
[1] VOLUME
[1] SRC Speech RX Volume
[5]5_lvl : 88
Menu -> Key Input
Change to any number greater than 88 (Max:100)
OK
Press back to save.
Default values:
0_lvl: 63
1_lvl: 68
2_lvl: 73
3_lvl: 78
4_lvl: 83
5_lvl: 88
It will reset after a reboot so be sure to run through it again if you wish to increase the volume level again. There isn’t enough testing done or reports at this time to tell if moving the volume past 88 will damage or blow out your speaker. So as usual if this mod blows out your speaker you are using at your own risk.
Dialer: *#*#197328640#*#*
[5] AUDIO
[1] HANDSET
[1] VOLUME
[1] SRC Speech RX Volume
[5]5_lvl : 88
Menu -> Key Input
Change to any number greater than 88 (Max:100)
OK
Press back to save.
Default values:
0_lvl: 63
1_lvl: 68
2_lvl: 73
3_lvl: 78
4_lvl: 83
5_lvl: 88
It will reset after a reboot so be sure to run through it again if you wish to increase the volume level again. There isn’t enough testing done or reports at this time to tell if moving the volume past 88 will damage or blow out your speaker. So as usual if this mod blows out your speaker you are using at your own risk.