Originally Posted by Korey_Nicholson
Select charging and unchecked diagnosis ports
Sent from my SPH-D710 using xda premium
I understand that, and I have done that. My point is my computer doesn't recognize that a device is even being connected. I am 100% sure that the drivers are installed because i just did an odin today from both a windows 7 x64 desktop and a windows 7 x86 laptop. I even tried doing it before I odined and was on an EI22 BML Rom.
I've read the instructions several times, but just to be sure:
-USB Debug OFF
-##8778# and have both set to MODEM
-When connect phone choose CHARGING or TETHERING (Computer should recognize a device and install as necessary - THIS DOES NOT HAPPEN!!)
-In QPST when I click Add New Port even if the "Show Serial and USB/QC Diagnostic ports only" box is unchecked, there are no COM ports that show up.
I cannot figure out how to make my epic show up on my computer as a COM port. Any other suggestions?