Thank you for your honesty.
I'll try to use my technical knowledge to search a solution by myself.
Where can I find BT sources? How can I know if *.csv files I put at the root of my SC card are used by Android or not? Where can I find exolanations or information on internal structure and design of these csv files?
I'll tell you if I find something ...
getprop | grep gsm.version.baseband
Hey everyone. I have a couple questions and I'm not entirely sure my problem doesn't stem from the WinMo ROM I'm using... (Also, I'm using a Raph110 Fuze, if that has any bearing on my problems.)
First, when the touch screen calibration step comes up, I get no indication of it other than the booting appears to stall. When I touch where I think I should (somewhere near the upper left), I'll see the upper right box appear, then part of the center, then part of the lower left then the lower right. The calibration takes, but I don't know how off it is because of the first tap location...
Second, I can't for the life of me get wifi working. I tap to activate it, it shows that it's starting for a few seconds, then it just says 'error' under the wifi checkbox.
I was hoping that I could, at the very least, get wifi working so I could use Skype or Palringo or something since I don't have AT&T any more...
It's the ROM on page 1 I just downloaded today. The software itself says kernel version 18.104.22.168. I may have logs, but I'll have to look up how to extract them. I read the FAQs for the various "Android on Fuze" sites and the only thing regarding wifi is "It works." Nothing about a 'wifi-nvram' trick... (Again, searching for that phrase returns your above post...)
|Thread Tools||Search this Thread|