Originally Posted by Andych

If you have a P3600i then according to the info you have above....you downloaded the WRONG Hard SPL.
Go back to the very first post on this thread and read it carefully. There is a link there to the correct Hard SPL from Olipro...and it isn't 130, 120 or Des Crash Proof.

Now I see... I've seen the V1.1 in the filename and considered that it was an old version ( at that moment I had the trinityguide.info opened ) ehehehe



Hahahahah Incredible how it worked! That was pure lucky! lol


BTW do you know the answer to my other question? I mean leave the Hard SPL screen and proceed to normal boot.

JUst FYI after updating the HARD SPL Olipro3.20 I could update normally.

Hours of stupidy were wasted yesterday

bump muhaha

just to push it back up the top for anyone looking for instructions

Make it sticky!!!

Originally Posted by joncgde2

bump muhaha

just to push it back up the top for anyone looking for instructions

Originally Posted by gallevy

Make it sticky!!!

I'm gonna stick this with regards to the Trinifin (P3600I) users!

Originally Posted by tnyynt

I'm gonna stick this with regards to the Trinifin (P3600I) users!

Many thanks Tnyyny.

Thanks.. and please make the p3600i rom collection sticky too

Please make it sticky... many thanks...

someone who speak spanish will can write a private please?¿
I´ve an important problem with my p3600i
thanks

Hi,

I have been away for a whole and notice that the 3600i can now be flashed. Congrats to those who had the time and inclination to provide this service. I notice that you need to use activesync. My issue!

I use Linux on my one and only PC, where does that leave me?

tchoklat

run a virtual pc and install windows on it?

i don't know if it's possible to flash from linux, but for the time it would take to set up a virtual pc (try virtualbox, or something), it's probably just easier to do it from windows