You don't have to modify the provided source to get it to boot. At any rate, here is the guide:
# parted /dev/sdb print Model: SanDisk uSD SDDR-289 (scsi) Disk /dev/sdb: 1948MB Sector size (logical/physical): 512B/512B Partition Table: msdos Number Start End Size Type File system Flags 1 66.0kB 1948MB 1948MB primary fat32 boot, lba
Yeah, 0x80008000 is where you should make the uImage load and execute. When you put in the SD card, does it bootloop, or does it just continue to the internal uImage?
It sounds like it's just going to the internal storage and ignoring the SD card's kernel outright.
If that is the case, I am guessing it is a problem with uBoot. Try recompiling it from the B&N source (using the omap_gossamer config IIRC), then stick the produced files in the SD card's boot partition. If you don't want to do that you could try taking all of the files ending in .bin from mali100's Nooter image and putting them in the boot partition.
Finally, the partitioning at my SD card may be wrong (partition offset, flags, maybe something else), so I'd like to verify that too with somebody's listing.
|Thread Tools||Search this Thread|