So, can't say something about the OLD battery driver on new rom, it has to charge now.
First impression, you are on the right way, schlund. This looks very promising!

I did a clean install, coming from latest german WM.
After booting first time i set wallpaper, deleted some widgets from Homescreen, rebooted to Recovery, flashed gapps from post #707 and restarted. Then i installed Titanium Backup and restored only Wifi Data.
But i couldn't get a connection managed to my router, i didn't have a MAC Address, it was empty.
So i did again wipe/format all, and set up immediately after first boot (again no MAC) my Wifi Data by hand, but this time it worked! And now, MAC Address is there

What i also can say:
i had to set cpu frequency up, cause some apps (for example camera, could not make a shot until cpu was changed) always asked me "App does not respond. Close or Wait"


Some minutes ago i did a GPS Test and WOW, 7 Satellites in some seconds (in the house, not outside). Awesome!

Schlund, did you do anything to gpu driver since last release? I noticed some improvement in graphics performance but it may be well just a placebo effect. Does your release have updated adreno 200 driver as in derefas' release? Will benchmark against other roms later. Regards

ps. during some calls I experience delayed echo of my own voice. Never happened with ICS. Is it a common problem ?

I'm using 18.06 rom, not experimental.

look forward with excitement

Hello guys.

Yesterday i flashed the experimental version of schlund.
I flashed it with the touch CWM Recovery by munjeni and the WIFI gives an error.
Then i tried both CWM Recovery 5.0.2.8 and the TWRP-recovery-2.1.8 but the same error again.
Finally i tired with the CWM Recover from the first post (5.0.2.7) but again the same error.

Can you guys tell me what recovery did you used to flash the rom?

I use CWM Recovery 5.0.2.8.
Do you use LK bootloader from this thread, first post?

Originally Posted by old.splatterhand

I use CWM Recovery 5.0.2.8.
Do you use LK bootloader from this thread, first post?

Yes i did.Still no luck

---------- Post added at 09:21 AM ---------- Previous post was at 09:12 AM ----------

Ok problem solved

I used a version of derefas and it worked!

Originally Posted by spithash

Yes i did.Still no luck

---------- Post added at 09:21 AM ---------- Previous post was at 09:12 AM ----------

Ok problem solved

I used a version of derefas and it worked!

Please be more specific by providing a version and download link

Originally Posted by MobileMini

Please be more specific by providing a version and download link

Schlund must give the answer to this question.

I used the old method and the wi-fi works but the battery is not good

Welcome back schlund :)

---

I switched from munjeni's ICS version to cm-7-20120618-UNOFFICIAL-photonic-r10 and the battery discharge quick fast as hell especially over night, the phone shutdown.
Than i read ericsonicsson reply and i remember the hidden settings and i set GSM auto(PRL) as he mentioned.
Now the discharge is much better, how could this be?

Hey guys,
finally phone went off tonight, yeah.


the phone did it more than 4 days now, but many of you make a different experience. Why ?

There are many possible reasons:
1. your phone is not fully charged: the charging part of the old battery driver is ****, your phone can charge up to 4,2V(+-50mV) the driver says "full" after ~4020 mV

2. your battery level isnt correct: under heavy usage (300mA+) the level goes down and up under low usage, the lower the voltage the bigger is the difference, this causes your phone to turn off too early.

3. USB doesnt turn off: this is a bug in kernel that happens "sometimes" and will prevent the device to go to suspend

its my goal to fix these things in next battery driver.