ive download 2 diffrent stock odim roms but when i flash them i just get boot loops
both of the roms ive downloaded contain the one tar file so i flash it per OP
but i just get reboots so i have to reinstall the ics rom
can some one post a link to a GB rom that has all of pit,bootloader,pds,phone and csc in the one file
thanks

Ignore that last message
Downloaded one from http://forum.xda-developers.com/show....php?t=1102881

Sent from my GT-I9000 using xda premium

Thank you :)

---

Thank you for the simple guide I downgraded from ICS to JW6 and got stuck in a bootloop, your guide helped me out of that

Thanks man, brilliant guide. Helped me a lot.

As I was busy I couldn't reply to all posts but I am happy this helped you all.

Do we really need a repartition ?
Can we downgrade from ICS to GB without this ?
Most of the forum suggest not to do that as it can lead to hard brick.

Re: [GUIDE] Downgrading from ICS to Gingerbread i9000

---

Originally Posted by sk76

Do we really need a repartition ?
Can we downgrade from ICS to GB without this ?
Most of the forum suggest not to do that as it can lead to hard brick.

Do you have any better option to switch from ext4 to rfs?
Odin + PIT 512 + repartition prepare partition layout for Samsung stock ROM using rfs.
http://forum.xda-developers.com/showthread.php?t=999097

Thanks...
what if i am on a custom ROM like CM9,are the steps the same to going back to stock?

Re: [GUIDE] Downgrading from ICS to Gingerbread i9000

---

CM9 = ICS = Android 4.0.4

Originally Posted by SCIENTYREAL

I write this guide to help you, since I've had problems downgrading from ICS to Gingerbread.

Things you need:

1. Samsung drivers
2. Stock Gingerbread firmware with individual files (including bootloaders) I used JVZ Firmware
3. Odin

Procedure:

1. Install Samsung Mobile Drivers
2. Open Odin
3. Get the phone to the Download Mode by pressing(VolumeDown+Home+Power) buttons and connect the phone to your PC (your phone should be recognized)
4. Select PIT (usually 512)
5. Select BOOTLOADER (APBOOT)
6. Select PDA (CODE)
7. Select PHONE (MODEM)
8. Select CSC (CSC)
9. If 'Re-Partition'is not checked under 'Option', check it.
10. Press the Start button

Note:
If you want to upgrade to a later firmware (eg JW6 - It has only one .tar file),

1. go to the Download Mode again select the file under PDA.
2. DO NOT select the PIT, BOOTLOADER, PHONE, CSC files.
3. DO NOT check 'Re-Partition'.
4. Press the START button.

Hope this post helped you.

Possible to downgrade for GT-P1000