10.1.3 Wont Boot With Sd Card In Nook
Hey guys,Ive worked with CyanMod's images for several years and think they are great!
That being said CM7 worked so well I hadnt even considered anything else, I thought it had reached the pinnacle of what the NC could do, then I read about the new company and found out about 10!
Having messed up some previous tablets in a huge way I started by installing 10.1.2 to an SD card and working with it for a week, following the instructions found here:
everything seeme dto work well, including allowing my 7yo to play a game that I though was beyond the capabilities of the NC, turns out it wanted 4.x!
So after a week I used some instructions found on the same site to wipe that NC (I have 3) and install 10.1.2 to the eemc.
Again everything went smooth , until I put in an SD card, then the NC stopped in the boot slash screen (CMG logo w/ the circle spinning around it) and stayed there for up to 20 minutes, finally I gave up and turned it off.
thinking I had something left on the card I wiped it, re partitoioned it, formatted it 3 ways from sunday. Same result each time.
Then I tried another card, thinking I had one go bad, nope same result each time.
Last night seeing all the new info and fioxes in 10.1.3 I thought I try that
The instructions on choorucode were very straightforward and basically consisted of the following:
1) factory reset
2) delete cache
3) go into recovery and install cm-10.1.3.2-encore.zip
4) then gapps-jb-20130812-signed.zip
I'm sorry I dont actually have the link to those instructions, had to reboot the pc, but again from choorucode's site.
Anyone see anything I should not have done, did in the wrong order or just fubared?
Is this a limitation of 4 on the NC?
any and all ideas appreciated.