Originally Posted by becer
I have tried Mokee, but direct return to Quarx compilation made big stability problems too. Solution was to flash with original rom, then rooted one, 2ndInint and Quarx cm10, then cm11.
As I had Android 2.3.6 (22.214.171.124 - 231), I used these roms - http://forum.xda-developers.com/show....php?t=1542956.
It is very important to wipe data and cache just after first, original flash - otherwise you will have infinite boot loop and cannot run phone.
Look at http://forum.xda-developers.com/showthread.php?t=966537 too.
Im phone is f*****
, what I did is install this framaroot and installed rootchecker..... I tried to do the rooting using "installsu" and then clicked Gilmo and it gave me this message:
“Half-Success :-/ … system partition is read-only, use local.prop trick. Reboot your device and use adb to see if it runs as root”
then I restarted my phone and check with root checker and found its saying its saying Root access successful and then I wondered which I suppose I shudnt have wondered
to user framaroot and do the "unroot" and again restarted , and now after restart I tried to do the regular thing wipe cache ,Dalvik , Data and the phone is not even mounting them its sayin
E: Can't mount /cache/recovery/command etc
Im able to open the android 4.1.2 (Jb - quarx)
but not able to install a thing in my internal memory coz I messed up bad with the partition table bad
I tried to fix it through this
but no luck :/