Post Reply

[Q] trouble installing cm s0.2 on Nook color

6th February 2014, 10:26 PM   |  #1  
OP Junior Member
Thanks Meter: 0
 
3 posts
Join Date:Joined: Oct 2013
More
I had previously installed cm 10.2 on my nook. When its battery ran down completely and I restarted I lost the android system.
I have tried to re-install cm 10 on this same unit via the sd card, but although the cyanomod loader is there, the system doen't start up. Rather the nook blinks and then boots the Nook system.
I need suggestions.
7th February 2014, 01:10 PM   |  #2  
Senior Member
Thanks Meter: 33
 
159 posts
Join Date:Joined: Feb 2011
More
So you had 10.2 on the SD card. Through cyanoboot can you enter recovery? (hold the n button to get into the menu.)

Quote:
Originally Posted by txkatylarry

I had previously installed cm 10.2 on my nook. When its battery ran down completely and I restarted I lost the android system.
I have tried to re-install cm 10 on this same unit via the sd card, but although the cyanomod loader is there, the system doen't start up. Rather the nook blinks and then boots the Nook system.
I need suggestions.

7th February 2014, 10:54 PM   |  #3  
OP Junior Member
Thanks Meter: 0
 
3 posts
Join Date:Joined: Oct 2013
More
Can't get cm 10.2 to run on Nook color
Quote:
Originally Posted by wmuflyer

So you had 10.2 on the SD card. Through cyanoboot can you enter recovery? (hold the n button to get into the menu.)

I should have been more specific. I tried to get it to run on the original sd card, but in my attempts that card became unusual. I bought a 4gb,Kingston and have been trying to get that card to run. But the nook insists on booting into the Nook system. Again when I use SDFormat and then win32diskmanager to write generic sdcard v1.3 cm7-9-10 img to the sd card everything seems good. Then put the gapps and cm10 zip files on the card along with uAltimg and uAltram. With the card in the Nook, I restart and the penguin appears and the loading proceeds to shutdown. On restart no cyanomod circle or boot into cyanomod. Any suggestions appreciated. This is very frustrating since I succeeded previously.
Post Reply Subscribe to Thread
Previous Thread Next Thread
Thread Tools
Display Modes