in the youtube video..it's mention that you must have about 60% battery or above so fast_boot will tell you "battery OK" but in your case you've a low battery that's why fast_boot tells you "battery low".
Originally Posted by angelflames1337
Hi there, thanks for replying. As I mentioned in my first post, my phone wont boot up when connected to the PC. It can only boot when connected to the wall charger. So I cant really flash it using RSD Lite. Is there anyway to work around this problem? When in fast boot mode (and connected with wall charger), it says battery low cannot program. Does this means something?
The only solution to recharge it is to take battery off from phone and charge it using another atrix or a generic battery wall socket or any other method as phone itself will never charge the battery in Soft Brick...
I had the same issue before
but I used a small trick to charge my battery..I've an Arduino board "small development board" came with an adapter 7V 1amp so I take 2 wires from the arduino and connect that adapter "inner is + and outer is -" to the battery "look at the battery back it's mention where is + and where is -" and waited for an hour then put battery back in phone and enter fast_boot mode then voila!
it said battery OK which means it has been charged successfully then FXZ normally.
Note: be sure to connect positive+ at adapter to positive+ at battery and same connect negative- to negative- DON'T reverse the signs.