[Q] Digitizer problems

55 posts
Thanks Meter: 7
By mschipperheyn, Member on 5th May 2014, 12:09 PM
Post Reply Subscribe to Thread Email Thread

I have a question regarding to a digitizer that suddenly started going on the blink, meaning sometimes it doesn't work at all. The screen works normal but it doesn't respond to input. If it doesn't no amount of restarts will help. But if I let the phone turned off for a night, in the morning it will often just work.

I disassembled the phone and checked that the connector was properly connected and it seems to be (I took it out and put it back in). There is no obvious damage on the phone.

I was wondering if there are any known causes for this behaviour. I could just order another digitizer and install that, but since there is no visible damage, I'm a bit worried that it'll just be the same problem. Could it have something to do with the battery? I still have the original and it's not exactly great anymore. I run Shantur's CM11.

Last edited by mschipperheyn; 5th May 2014 at 02:46 PM.
5th May 2014, 08:14 PM |#2  
OP Member
Thanks Meter: 7
This is prob it
Prob this is it:
Post Reply Subscribe to Thread


Guest Quick Reply (no urls or BBcode)
Previous Thread Next Thread
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes