I recently started messing about my DS5 and apparently bricked it. I can't remember exactly what was I doing when this happened but the current situation is the following: the device can be powered normally (just pressing the power button) but I will get stuck at the dell logo, even before it animates; it will NOT go into fastboot (black screen if powered on while pressing the camera button) and it will NOT go into recovery mode either (pressing the volume knobs while powering it on). It does however go into diagnostic mode (plugging it in while pressing the volume up button) and the QDL tool will recognize it.
I have tried two different QDL tools; one (from streakflash) ends the process in success and the other (from the repairtool) times out while waiting for the ADB.
QDLTool 184.108.40.206 -from streakflash- (incomplete; last) output:
Baseband image version: M8650BAUSB1AM5035SIGN Check device and image is Austin Open COM port success Test communication success Check Secure Boot is enabled #DBL to DDR success #FSBL to DDR success #OSBL to DDR success #AMSS to DDR success #DSP1 to DDR success #DT to DDR success #APPSBL to DDR success #backup FSBL to DDR success #backup OSBL to DDR success #backup DT to DDR success #backup APPSBL to DDR success Run HEX success Check Secure Boot is enabled Streaming hello success Send Security mode success Download partition table success #Download DBL success #Download FSBL success #Download OSBL success #Download AMSS success #Download DSP1 success #Download DT success #Download APPSBL success #Download backup FSBL success #Download backup OSBL success #Download backup DT success #Download backup APPSBL success Erase EFS2 success Wait for rebooting ....... ok Wait for modem set up ...... Download success - 2014/04/25 10:09:59 Elapsed Time: 83.65 sec
QDLTool 220.127.116.11 - from repair tool- (incomplete; last) output:
Erase EFS2 success Wait for rebooting ....... ok Wait for modem set up ...... Wait for ADB device ......... ERROR[D2]: wait ADB fastboot mode timeout! Please check that device is exist and driver is properly installed. Download Fail! - 2014/04/25 10:06:01 Elapsed Time: 30.64 sec
I've tried everything that has been published on the forums, including, but not limited to:
The ADB is installed (used the Dell) but the device manager never even shows an Android phone at any point, immediately after the reboot it will simply be picked up as a "Qualcomm HS-USB Diagnostics 9002" and hence (I guess) the failure to run adb fastboot.
I am almost certain that the adb is correctly installed but I can't be 100% sure. What else can I do?