[SHG-i537] ML2 SafeStrap Flashing Guide
I cannot and will not be held responsible for anything that may happen due to you following this guide. You are directly
responsible for anything that you instruct your device to do. By following this guide, you accept full and complete
responsibility for whatever the outcome is.
After much trial and error, this guide should help those of you stuck on stock ML2 get to running ROMs through SafeStrap 3.71
Before anything, a thanks goes to spegelius and Devo7v for helping with the much needed files. Without them, I would not
have gotten this far.
* You need to be on 4.3 ML2 as your stock firmware
* You need to be rooted. If you are not, read this: http://forum.xda-developers.com/show....php?t=2690133
* You will need to have SafeStrap 3.71 installed. Check here: http://goo.im/devs/Hashcode/jflteatt-active/safestrap
**Verify that you are using the SHG-i537 BEFORE installing anything**
Once you have that done, boot into recovery and create a new ROM slot.
It will take a few minutes for the slot to create and setup.
Once it has setup, grab your favorite TW ROM and flash 'er to the slot. (I used HyperDrive)
Now, flash the ML2 modules, followed by the MF5 camera prop archive.
Now flash the GPIO keys archive.
Clear the dalvik and cache, and reboot.
This should give you hardware keys, wifi, bluetooth, NFC, and Camera.
I know this is not the most comprehensive guide out there, but it should be enough to get you up and running.