Welcome to XDA

Search to go directly to your device's forum

Register an account

Unlock full posting privileges

Ask a question

No registration required
Post Reply

A Little help please...

OP LightArrow123

22nd May 2014, 04:29 AM   |  #1  
OP Junior Member
Thanks Meter: 0
 
17 posts
Join Date:Joined: Nov 2010
So I bricked my device over a month ago. I installed a rom from the wrong version of the hox, it wasn't the at&t variant. Then for some reason, I decided to try to flash a ruu, it finished flashing but now my phone will only go into usb interface mode on devicemanager and qhusb_
22nd May 2014, 04:33 AM   |  #2  
timmaaa's Avatar
Recognized Contributor
Flag Melbourne
Thanks Meter: 7,577
 
15,561 posts
Join Date:Joined: Jun 2011
Donate to Me
More
You need a jtag repair, only way to save it if it's in QHSUSB_DLOAD mode. Should probably do some reading before attempting anything else on the device once it's fixed too, to save this from happening again. The threads in my signature would be a good place to start.

Sent from my Evita
22nd May 2014, 04:03 PM   |  #3  
redpoint73's Avatar
Recognized Contributor
Thanks Meter: 3,373
 
7,763 posts
Join Date:Joined: Oct 2007
Were you s-on and SuperCID, and did you try to run a Jellybean RUU? If so, that is a known brick situation. QHSUSB_DLOAD means you have a true brick and need JTAG as timmaaa said.

If S-on and superCID (plus JB RUU) and you flashed a ROM for the ENDEAVORU, that is a lot of mistakes caused by lack of research and lack of care while modding the phone. Again, like timmaaa I recommend more reading and understanding before messing with this or any phone.
Post Reply Subscribe to Thread
Previous Thread Next Thread
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes