Post Reply

[Hardware] Digitizer not working after LCD+Digi assembly replacement

OP goose90proof

29th May 2014, 04:33 PM   |  #1  
OP Junior Member
Thanks Meter: 0
21 posts
Join Date:Joined: May 2011
I installed a new LCD+Digi assembly into an HTC Inspire 4G. The LCD powers on but the digi does not respond to touch. I even disassembled the phone a 2nd time and checked all the cables and connectors for contact/damage. I haven't ruled out the possibility that the hardware is bad, but I'm wondering if there are perhaps some nuances I could be missing. This is not my first time working on mobile phones. Thanks.
Post Reply Subscribe to Thread
Previous Thread Next Thread
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes