Welcome to XDA

Search to go directly to your device's forum

Register an account

Unlock full posting privileges

Ask a question

No registration required
Post Reply

No CWM after flashing

OP DaniuPL

31st May 2014, 07:42 PM   |  #1  
OP Member
Thanks Meter: 6
 
47 posts
Join Date:Joined: Apr 2012
Hello! I just tried to install CWM with Odin v3.04 [hlte-cwm-recovery-6.0.4.8-kk(0412]
All went fine, but after the progress Note booting into stock recvovery...
Knox remain 0x0, but device status is Custom.

BL:XXUEND3

Please Help D:
1st June 2014, 04:15 AM   |  #2  
antique_sonic's Avatar
Recognized Contributor
Flag Corner of the earth
Thanks Meter: 1,096
 
2,100 posts
Join Date:Joined: Aug 2009
More
Quote:
Originally Posted by DaniuPL

Hello! I just tried to install CWM with Odin v3.04 [hlte-cwm-recovery-6.0.4.8-kk(0412]
All went fine, but after the progress Note booting into stock recvovery...
Knox remain 0x0, but device status is Custom.

BL:XXUEND3

Please Help D:

U can try again to flash. Normally it will boot up directly into Cwm after flashing.
If never reboot into Cwm, after finish flashing, take out the battery directly, after few seconds put it back, and press the 3 combos: vol up + home + power. U should get the Cwm.

Sent from somewhere under the sky, at the corner of this rounded earth.
Post Reply Subscribe to Thread
Previous Thread Next Thread
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes