Originally Posted by Kate84
Sorry I don't have a solution to your problem, I myself haven't found any USB cable other than the OEM that won't trickle charge regardless of roms.
Your signature shows you're using CM10.
Before the OEM cable crapped out, were you able to charge it normally?
While using the tablet with the wall charger, the battery % goes up and not down?
Reason I'm asking is because when I use any CM10+ roms, I'm always stuck on with trickle charge.
The tablet thinks its trickle charging from USB and just slow drains away until it's dead.
Only way for me to charge it when it dies is to turn it off and leave it charging over night, all night long.
I know it's not the OEM wall charger and OEM cable.
I've went back to stock Nook, CM7/CM9 and the charger/cable works perfectly fine.
So that leaves either something is wrong with these CM10+ roms, or my Nook Table is a special case...
Yes, the OEM charger / OEM cable was charging fine on CM10. Trickle charge works overnight, but the way to speed things up a bit is, if the nook is fully discharged, plug it in and let it trickle till it boots, then turn it on, have it boot and shut screen off and leave it to charge. When the nook is 'on' but asleep, it trickle charges faster than a dead nook hooked up to a regular usb.
You are saying that a regular micro usb was charging quickly under cm7/9 and stock roms?
Cyanogen Mod 10
HTC Sensation z710a (Sensation 4G)
HBOOT: 1.27.1111 S-OFF
Recovery: 4EXT Touch v184.108.40.206 RC9
Firmware: 3.33.401.106 SuperCID
Battery: 1900 mAh Anker
ROM: Team Venom ViperS 5.1.0