I apologize if this has been covered but even after a search I couldn't find a resolution to this problem.
I use NFC tags with my phone to automate certain things to make my life a bit easier and prolong the battery life.
In my car I have a tag that is on my dock that gets scanned when I put my phone in it, to prevent the phone from scanning it multiple times I set up conditions in the NFC trigger app only to trigger the action if NFC tag is scanned AND not connected to any device (Bluetooth).
The actions that get triggered are as follows:
Power saver enable
Media volume 15
Ringer volume 7
Notifications volume 7
Launch double twist
Connect to (Bluetooth device address)
The first few times it worked like it was supposed to and connect to the device (Bluetooth car connect) instantaneously. Now however its doing everything but connecting to the device and I have to remove my phone from dock and insert again to rescan the tag, sometimes multiple times in order for it to connect. I have tried rearranging the order of steps in trigger but that didn't seem to help.
Phone is not rooted
Tag is Samsung tectiles 2
App used to program tag is NFC trigger
Attached are screenshots of the setup
Thanks in advance for any advice.