Originally Posted by tekkitan
I followed the steps exactly, but when I try to flash the full NF9 I get:
<ID:0/003> Odin v.3 engine (ID:3)..
<ID:0/003> File analysis..
<ID:0/003> Get PIT for mapping..
<ID:0/003> Firmware update start..
<ID:0/003> NAND Write Start!!
<ID:0/003> Complete(Write) operation failed.
<OSM> All threads completed. (succeed 0 / failed 1)
SM-N900T running NF9.
I'm not an expert, but comparing your output with mine, you abort at the point ODIN is trying to flash the cache (see my output below):
<ID:0/009> Odin v.3 engine (ID:9)..
<ID:0/009> File analysis..
<ID:0/009> Get PIT for mapping..
<ID:0/009> Firmware update start..
<ID:0/009> NAND Write Start!!
<ID:0/009> cache.img.ext4 <--- you never get to this point
<ID:0/009> RQT_CLOSE !!
<ID:0/009> RES OK !!
<ID:0/009> Remain Port .... 0
<OSM> All threads completed. (succeed 1 / failed 0)
Again, I'm not an expert, but I would suggest you first boot into recovery (Vol Up, Home Button and Power), and then proceed to Wipe Cache. If you don't mind losing your original config, you can also factory reset.
Then I'd try again. If it continues to fail, I would suspect that your NAND (?) is failing, but I doubt it, unless you've been flashing hundreds of times...