FORUMS

[HOWTO] Enable Wired Ethernet on P5110

3 posts
Thanks Meter: 2
 
By martburg, Junior Member on 24th April 2014, 04:20 PM
Post Reply Subscribe to Thread Email Thread
Dear Forum,

Wired Ethernet on a tablett HOWTO.

Tested on a P5110

Get ready to build CyanogenMod for Your Device
http : / wiki.cyanogenmod.org/w/Build_for_p5110
but before you build:
cd android/system/kernel/samsung/espresso10
make menuconfig
[Navigate using arrow keys and enter]
Load an Alternate Configuration File:
./arch/arm/configs/cyanogenmod_p5110_defconfig
then
Device Drivers ->
Network device support ->
USB Network Adapters ->
Multi-Purpose USB Networking Framework ->
[PRESS y so that the module will be built into the kernel] [*] Multi-purpose USB Networking Framework
find the Chipset Your Adapter is using
[PRESS y][*] ASIX AX88xxx Based USB 2.0 Ethernet Adapters
or whatever Chipset your Adapter is using

exit and save

build the ROM

Flash it
open terminal
su
netcfg

Your eth0 should now show up to get an IP Address

netcfg eth0 dhcp

The grapevine says not all apps are supported as Android has a sketchy implementation apps written in c or c++ should work
The Following User Says Thank You to martburg For This Useful Post: [ View ]
 
 
29th April 2014, 10:03 AM |#2  
iamashwin's Avatar
Senior Member
Flag Mysore
Thanks Meter: 358
 
Donate to Me
More
Quote:
Originally Posted by martburg

Dear Forum,

Wired Ethernet on a tablett HOWTO.

Tested on a P5110
.....
The grapevine says not all apps are supported as Android has a sketchy implementation apps written in c or c++ should work

What would ./arch/arm/configs/cyanogenmod_p5110_defconfig be on a p3110?
27th May 2014, 12:04 AM |#3  
Senior Member
Thanks Meter: 20
 
More
Easier will be to flash Agni kernel and install this app from store. Is using a little hack so every app works with the wired connection https://play.google.com/store/apps/d...a.usbhost.test
12th February 2015, 09:08 PM |#4  
Junior Member
Thanks Meter: 2
 
More
I"ve been scratching my head for a while on this one. Here's what I did to get ethernet access with the help from above. Thanks iamashwin and blueseeker.

1) From TWRP v2.8.4.0 in boot recovery, flash the following:
- Recent version of OmniRom 4.4.4 nightly. I used the 2/12/15 nightly.
- Flash PA Gapps Micro for 4.4.4
- Flash SuperUser
- Flash AGNi kernel for 4.4.4
- Reboot
2) Load this android app.
2) Make sure wifi is turned off.
3) Plug in your USB-OTG adapter with USB-Ethernet adapter. I bought this USB-OTG adapter and this USB-Ethernet adapter.
4) Run ethernet app that you downloaded from 2) above. Hit "Enable".

You should be good to go from here.....
23rd March 2015, 07:42 PM |#5  
Member
Flag Kingston
Thanks Meter: 0
 
More
Samsung Galaxy Tab 3 10.1" P5200.
Hello I want to get a similar configuration setup on my Samsung Galaxy Tab 3. Is there any way that modifications can be made to what's been used here to support it.
Post Reply Subscribe to Thread
Previous Thread Next Thread
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes