Follow the guide as stated and it does work, fought it at first as well.
Coming from tizen-
Boot to download mode
uncheck auto reboot
check re partition and f reset time
select the pit and tar as shown
Once it's finished flashing unplug watch and remove from cradle
hold power button down till you see rebooting
push it 10 times or so and then select recovery
wait a minute or so and you will get the error message
plug back up to computer and using a new Odin terminal
uncheck auto reboot and flash recovery as shown
once it finishes reboot by holding power again
boot back to recovery and let it do it's deal
Watch will then reboot and you are done.
Issue comes up if you don't do it exactly as the op stated. Took me a few times to figure out exactly how to do it as well.
1. Download file(use chromium-browser)
2. uncompression SM-V700_tizen_to_android.zip
3. excute Odin
4. flash 1_dn_android.tar
5. reboot to recovery(Power button press 10sec > press power button 10times > recovery)
7. The following message is displayed,
8. flash 2_recovery.img.tar
9. reboot to recovery(Power button press 10sec > press power button 10times > recovery)
10. boot done
I tryed to downgrade from tizen to android.
I was almost successful, however i encountered the touchscreen not working problem.
I was following this post procedure:
However by mistake i ended up choosing the wrong menu option (recovery) i think
when i should have been using download.
unfortunately choosing either 'Continue' 'Download' or 'Recovery' in the menu results the the samsung logo
bootloop problem. Odin does not see/recognise my watch anymore.
Is there any hardware way to correct this problem, can a chip be reflashed ?, or is my SM-V700 Watch
now officially a brick for life ??
Please help me, i'm desperate at this point
|Thread Tools||Search this Thread|