TS Dev in Power Loop
Rezzin an old thread:
My TS is in a power boot loop, where the screen stays blank at all times, aside from a brief flash of full white every 6 seconds, when plugged in. It never gets past this, and it does it after a battery pull, and even without the battery in it. Windows just keeps making the USB connect/disconnect sounds on loop, every 2 seconds or less. I have a video of this.
I've followed the posts and tips, but I cant get it past this, which means the computer cannot interact with the watch. I've tried removing all old drivers with USBDeView & DevMgr, but I dont think that matters if the device cant get past the initial power sequence.
BROM ERROR: S_FT_DA_NO_RESPONSE (4001)
DA didn't send response data to Flash Tool!
Dead, or just dumb?