[Q] stock rom flash fail
-sorry for my english I dont speak well but...
I was testing cyanogemod 10.1.3 for a while but then I decided get back to stock rom, did full wipe and put this ROM I9505XXUBMF8 into Odin and start flashing but he said this:
<OSM> Enter CS for MD5..
<OSM> Check MD5.. Do not unplug the cable..
<OSM> Please wait..
<OSM> I9505XXUBMF8_I9505OXABMF8_I9505XXUBMF8_HOME.tar.md 5 is valid.
<OSM> Checking MD5 finished Sucessfully..
<OSM> Leave CS..
<ID:0/003> Odin v.3 engine (ID:3)..
<ID:0/003> File analysis..
<ID:0/003> Get PIT for mapping..
<ID:0/003> Firmware update start..
<ID:0/003> NAND Write Start!!
<ID:0/003> FAIL! (Auth)
<ID:0/003> Complete(Write) operation failed.
<OSM> All threads completed. (succeed 0 / failed 1)
-then I couldnt go to system, recovery just to download mode so I flashed TWRP.
(I tried another stock rom, odin, PC but always same problem.)
-then i tried get back CM 10.1.3 via TWRP and it flashed and work without problem.
-then I tried flash omega rom via TWRP and it flashed without problem but booting is very slow and during the logo Samsung it takes about 10mins to boot into system and device is very hot.
-Everything about Kies and antivirus is off.
-Using just original USB cable.
-what says download mode:
PRODUCT NAME: gt-i9505
CURRENT BINARY: CUSTOM
SYSTEM STATUS: CUSTOM
KNOX KERNEL LOCK: 0X0
KNOX WARRANTY VOID: 0X1
WRITE PROTECTION: ENABLED
START [224, 1440]
SW REV, CHECK FAIL : FUSED : 2 , BINARY : 1
Any ideas how to resolve this?