I'm thinking i might have some Serial data issues but I'll have to hook up a scope to my first build and see. If i do I will just have a some line drivers in there and that should clear up most of those issues. I think the on the other side of the connector on the GTAB there are some line drivers/buffers so I might be OK. I will try and build a board tonight and get a bill of materials written up and try this thing out.
---------- Post added at 01:35 PM ---------- Previous post was at 12:45 PM ----------
I did not expect to run into the situation of not being able to find the female gtab connector. I might either change the design to two USB ports, one male and one female or I might just buy a desktop dock and create a board of the same size and install it in there.....
---------- Post added at 01:35 PM ---------- Previous post was at 12:45 PM ----------
I did not expect to run into the situation of not being able to find the female gtab connector. I might either change the design to two USB ports, one male and one female or I might just buy a desktop dock and create a board of the same size and install it in there.....