[DEV] Android for Blue Angel (PXA Droid)

GuestK00433 · Jun 3, 2012

gbl08ma said:
Put the BA to charge. My BA sometimes gets stuck in the bootloader or even before it (at a white screen) and usually the problem is low battery.

Other than that, are you sure it was "/system/yadayadayada"? I don't think there's such a thing (d-two, please confirm).

by yadayadayada, i ment lots of random stuff.
heres what happened:

A N D R O I D BT_RADIO going: off
TOSA_BT: going off
init: cannot find '/system/bin/servicemanager', disabling 'servicemanager'
init: cannot find '/system/bin/void', disabling 'void'
init: cannot find '/system/bin/netd', disabling 'netd'
init: cannot find '/system/bin/debuggerd', disabling 'debuggerd'
init: cannot find '/system/bin/rild', disabling 'ril-daemon'
init: cannot find '/system/bin/app_process', disabling 'zygote'
init: cannot find '/system/bin/mediaserver', disabling 'media'
init: cannot find '/system/bin/dbus-daemon', disabling 'dbusd'
init: cannot find '/system/bin/installd', disabling 'installd'
init: cannot find '/system/bin/keystore', disabling 'keystore'
init: cannot find '/system/bin/sh', disabling 'console'
Enabling adb
adb_open

So can anyone help?
Its formatted to FAT, it is 2GB (not sdhc)

ares93 · Jun 3, 2012

d-two said:
Yes, why?

You develop for Leo as well? I haven't seen you anywhere in the Leo forums...

EDIT: My bad, missed that you are running WM6.5, I left that behind a long time ago.

d-two · Jun 3, 2012

ares93 said:
You develop for Leo as well? I haven't seen you anywhere in the Leo forums...

EDIT: My bad, missed that you are running WM6.5, I left that behind a long time ago.

I have test the WP7 and ICS but the Camera is on both not so good like in WM6.5

And for this project i must make many videos and pics

Looks good

<4>htcblueangel_wlan_init: acx-mem platform_device_register
<6>acx.acxmem_probe: found ACX100-based wireless network card
<5>acx.acxmem_probe: initial debug setting is 0x000A
<5>acx.acxmem_probe: found an ACX100-based wireless network card, irq:81, membase:0x2c000000, mem_size:33, iobase:0xc8974000
<5>acx.acxmem_probe: the initial debug setting is 0x000A
<5>acx.acxmem_probe: using IRQ 81
<5>acx.acxmem_probe: request_irq 81 successful
<6>acx.acx_show_card_eeprom_id: EEPROM card ID string check found empty card ID: is this a DWL-650+ variant?
<6>acx.acx_init_task_scheduler: device IS_MEM
<6>acx.acx_reset_dev: ACX radio type 0x0d
<5>acx.acx_read_fw: requesting firmware image 'WLANGEN.BIN'
<6>acx-mem acx-mem: firmware: requesting WLANGEN.BIN
<5>acx._acx_upload_fw: acx_write_fw (main): 0
<5>acx._acx_upload_fw: acx_validate_fw (main): 0
<5>acx.acx_upload_radio: firmware: RADIO0d.BIN
<5>acx.acx_read_fw: requesting firmware image 'RADIO0d.BIN'
<6>acx-mem acx-mem: firmware: requesting RADIO0d.BIN
<5>acx.acx_upload_radio: acx_write_fw (radio): 0
<5>acx.acx_upload_radio: acx_validate_fw (radio): 0
<5>acx.acx_init_packet_templates: initializing max packet templates
<6>acx.acxmem_copy_from_slavemem: copy_from_slavemem: warning! destination not word-aligned!
<5>acx.acx_create_hostdesc_queues: notice IS_PCI(c54fb900): 0
<6>acx.acxmem_copy_from_slavemem: copy_from_slavemem: warning! destination not word-aligned!
<5>acx.acx100_init_memory_pools: TotalMemoryBlocks=62 (15872 bytes)
<6>acx.acx_parse_configoption: NVSv: 03 0D 05 00 01 21 00 00
<6>acx.acx_parse_configoption: NVS_vendor_offs:0000 probe_delay:500 eof_memory:65536
<6>acx.acx_parse_configoption: CCAModes:04 Diversity:01 ShortPreOpt:01 PBCC:01 ChanAgil:00 PHY:05 Temp:01
<6>acx.acx_parse_configoption: AntennaID:01 Len:02 Data:1E 00
<6>acx.acx_parse_configoption: PowerLevelID:0A Len:00 Data:
<6>acx.acx_parse_configoption: DataRatesID:02 Len:05 Data:02 04 11 22 44
<6>acx.acx_parse_configoption: DomainID:03 Len:07 Data:30 20 30 31 32 40 41
<6>acx.acx_parse_configoption: ProductID:04 Len:09 Data:TI ACX100
<6>acx.acx_parse_configoption: ManufacturerID:05 Len:07 Data:TI TesW
<5>acx.acx_get_firmware_version: Firmware: firmware_version='Rev 1.10.7.K' hw_id=01030505
<6>acx.acx_display_hardware_details: chipset TNETW1100B, radio type 0x0D (Maxim (MAX2820)), form factor 0x03 (Compact Flash), EEPROM version 0x05, uploaded firmware 'Rev 1.10.7.K'
<6>acx.acxmem_copy_from_slavemem: copy_from_slavemem: warning! destination not word-aligned!
<5>acx.acx1xx_get_antenna: Got antenna[0,1]: 0x8D 0x65
<6>acx.acxmem_copy_from_slavemem: copy_from_slavemem: warning! destination not word-aligned!
<5>acx.acx1xx_get_station_id: Got station_id: 00:09:2D:0F:EC:2C
<5>acx.acx_get_reg_domain: Got regulatory domain 0x30
<6>acx.acxmem_copy_from_slavemem: copy_from_slavemem: warning! destination not word-aligned!
<5>acx.acx1xx_get_cca: Got Channel Clear Assessment (CCA) value 13
<6>acx.acxmem_copy_from_slavemem: copy_from_slavemem: warning! destination not word-aligned!
<5>acx.acx1xx_get_ed_threshold: Got Energy Detect (ED) threshold 112
<5>acx.acx_get_sensitivity: got sensitivity value 176
<6>acx.interrupt_show_flags: HOST_INT_RX_DATA # IN: packet rcvd from remote host to dev
<6>acx.interrupt_show_flags: HOST_INT_TX_COMPLETE # OUT: packet sent from device to remote h
<6>acx.interrupt_show_flags: HOST_INT_CMD_COMPLETE # no docs
<6>acx.interrupt_show_flags: HOST_INT_INFO # no docs
<6>acx.interrupt_show_flags: HOST_INT_OVERFLOW # no docs - in BSD as ACX_DEV_INTF_UNKNOWN
<6>acx.interrupt_show_flags: HOST_INT_PROCESS_ERROR # no docs - in BSD as ACX_DEV_INTF_UNKNOWN
<6>acx.interrupt_show_flags: HOST_INT_SCAN_COMPLETE # no docs
<5>acx.acx_set_interrupt_mask: adev->irq_mask: before: 0 devtype:2 chiptype:1 tobe: 49660
<6>acx.acx_update_ratevector: new ratevector: 82 84 0B 16 2C
<6>acx.acxmem_copy_from_slavemem: copy_from_slavemem: warning! destination not word-aligned!
<5>acx.acx1xx_get_tx_level: Got tx-power-level: 1
<6>acx.acxmem_probe: net device phy0, driver compiled against wireless extensions 22 and Linux 2.6.32.9
<7>phy0: Selected rate control algorithm 'minstrel'

but android will the wifi not start?

d-two · Jun 3, 2012

zainuintel said:
by yadayadayada, i ment lots of random stuff.
heres what happened:

So can anyone help?
Its formatted to FAT, it is 2GB (not sdhc)

Have you copy all files in the root of SDCard?

GuestK00433 · Jun 3, 2012

yes, it is in the root of the card

swiss420 · Jun 3, 2012

zainuintel said:
yes, it is in the root of the card

Did you double check for consitency as mentioned earlier? Chkdsk or Ubuntu?

d-two · Jun 3, 2012

swiss420 said:
Did you double check for consitency as mentioned earlier? Chkdsk or Ubuntu?

or try an other SDCard...

d-two · Jun 4, 2012

New feature

I think i will make a new image on Friday

swiss420 · Jun 5, 2012

d-two said:
New feature

I think i will make a new image on Friday

I think that is a great idea.

What did it take to get it working?

d-two · Jun 5, 2012

swiss420 said:
I think that is a great idea. What did it take to get it working?

I have modify the Wifi driver and patch the wpa supplicant from Android

gbl08ma · Jun 5, 2012

That's great news. So what's left? From what I see on the first post, only GPRS and PIN input, fixing the sound, the keyboard backlight, the suspend/resume and the wake-up.
For the camera, probably we need to write a driver from scratch to put it to work, as none of the older Linux distros have a driver we can port to kernel 2.6.

d-two · Jun 5, 2012

gbl08ma said:
That's great news. So what's left? From what I see on the first post, only GPRS and PIN input, fixing the sound, the keyboard backlight, the suspend/resume and the wake-up.
For the camera, probably we need to write a driver from scratch to put it to work, as none of the older Linux distros have a driver we can port to kernel 2.6.

NO, the old camera driver has not work... The Camera is connect on the ATI chip and this was never fixed... Also not so easy ! PIN input and Suspend problem the same, was never fixed...

gbl08ma · Jun 5, 2012

What did I say? None of the old Linux distros have a working driver for the camera!

L]e[G · Jun 5, 2012

d-two if in new release you fix wifi, you can include google play (market) ?

d-two · Jun 5, 2012

gbl08ma said:
What did I say? None of the old Linux distros have a working driver for the camera!

I miss understood

d-two · Jun 5, 2012

L]e[G said:
d-two if in new release you fix wifi, you can include google play (market) ?

I think so...

L]e[G · Jun 5, 2012

many thanks

kainppc6700 · Jun 6, 2012

POLL Reply

L]e[G said:
d-two if in new release you fix wifi, you can include google play (market) ?

As an alternative instead of the "Google playland" (which is really annoying), I'd like to see this type of ROM for the iPAQ 4150.

Maybe we could put it up to a vote?

- 2B

notime2d8 · Jun 6, 2012

kainppc6700 said:
As an alternative instead of the "Google playland" (which is really annoying), I'd like to see this type of ROM for the iPAQ 4150.

Maybe we could put it up to a vote?

- 2B

iPAQ 4150 + 64mb of ram + android = fail

muckelmaus · Jun 6, 2012

d-two said:
NO, the old camera driver has not work... The Camera is connect on the ATI chip and this was never fixed... Also not so easy ! PIN input and Suspend problem the same, was never fixed...

PIN input never worked for HTC kaiser/vogue either!! Doesn't matter annyway, noone cares about! Unook SIM (permanently) first and then start haret.
Come one d-two, go for it! We all believe in you, little hero!

[DEV] Android for Blue Angel (PXA Droid)

GuestK00433

Guest

Senior Member

Inactive Recognized Developer

Inactive Recognized Developer

GuestK00433

Guest

Senior Member

Inactive Recognized Developer

Inactive Recognized Developer

Attachments

Senior Member

Inactive Recognized Developer

Senior Member

Inactive Recognized Developer

Senior Member

Senior Member

Inactive Recognized Developer

Inactive Recognized Developer

Senior Member

Senior Member

Senior Member

Senior Member

Similar threads

Top Liked Posts