Originally Posted by Droidatar
I am using CM10 on my nook color after spending 8+ hours yesterday finally being able to get back to where I started. I can again see my nook and the card but it is now showing up under portable devices. I used to have them listed as drives. this is fine as I have access to the card after I click on the nook in File explorer. I would like it the previous set-up just because Calibre has my card and device flipped and its easy to confuse me. I learned that if I can label my nook f and the card g Calibre will think the first letter is the main drive.
My original reason for this post: I can not find where to disable the automount in CM10 can you tell me where you disabled it? and if anyone can wave their magic wand and get me back to where I can name my nook and card THANKS
You need to activate USB Mass Storage in CM10. It uses MTP by default. Go to settings, storage, menu, USB computer connection and check off Mass Storage rather than MTP. Then they show up as drive letters instead of under portable devices. You may also have to activate in the notification area.
And I think in Windows you can control what the drive letters are. Go to manage computer and select disk management and you can change the drive letters.
Sent from my Nook HD+ Running CM10 on SD
See my Nook Color Tips Thread here
and my Nook Color EMMC Partition Repair Thread here
and my Nook Color Updated CM SD Installation Instructions here
and my Nook HD/HD+ stock tips thread here
and my Nook HD/HD+ stock CWM Root Tools thread here
and my Nook HD+ Hybrid CM SD here
and my Nook HD+ Updated Guide for Original CM SD Installation here