I just got version 5.8.1.9 from ROM Manager and I see that selecting the reboot option at the end I got again the CWR instead. I can only force reboot from cold reboot to get the ROM starting again. Basically I should wait for a new version to fix it or I need to correct it by myself as reported previously? Thanks
After you have flash a different recovery DO NOT use the Boot into system.
Instead cold boot into the OS and use Terminal Emulator to type in the following command.
Type : su (give permission if ask, choose YES). You should get a #
Type : echo boot | dd of=/dev/block/mmcblk0p3 bs=1 seek=0
Type : exit
Type : reboot
Note: Hit "Enter" after each line
This didn't work for me so I took out the exit command and it worked perfectly.. basically this
After you have flash a different recovery DO NOT use the Boot into system.
Instead cold boot into the OS and use Terminal Emulator to type in the following command.
Type : su (give permission if ask, choose YES). You should get a #
Type : echo boot | dd of=/dev/block/mmcblk0p3 bs=1 seek=0
Type : reboot
Note: Hit "Enter" after each line
Weird huh? I tried your original instructions about 16 times the last three days and was frustrated.. tried it without and it worked the first time.
Even weirder was I flashed gee one's stock rom and recovery and that worked but just boot looped Roach's CWM repack that came with the rom. I then did my method and viola.. All good.
Unable to flash, status 0
Sent from my Transformer TF101 using XDA
After you have flash a different recovery DO NOT use the Boot into system.
Instead cold boot into the OS and use Terminal Emulator to type in the following command.
Type : su (give permission if ask, choose YES). You should get a #
Type : echo boot | dd of=/dev/block/mmcblk0p3 bs=1 seek=0
Type : exit
Type : reboot
Note: Hit "Enter" after each line
Managed to get in the OS but i tried to install Roach and Rogue CWM over this one and it doesn't install... always comes up the same...
Any ideas?
ClockworkMod Recovery touch 5.8.1.8 for TF101 \G by JvS CoRp Original
Installation:
Just flash the attached zip from CWM.
Usual disclaimer applies: if you brick your tablet, it's not my problem!