Guide - Installing Firmware, CWM recovery & Rooting

Search This thread
By:
Advanced…
devil.chin2

devil.chin2

Senior Member
May 9, 2013
196
21
Guys I tried installing Cwm touch 6.0.4.4 on my micromax a116 it rebooted and lost the signals since then... Plz help guys...

Sent from my Samsung Galaxy S4 Mini GT-I9505 using xda app-developers app
 
A

adipos

Member
Jan 2, 2014
6
0
Advice needed

Hi there,
I have a Galaxy Note 10.1 N8005 (with sim card slot) bought from Turkey.Because this version has no phone function, I am wondering if I can flash with an European N8000 stock flash rom (I know this model has phone function).It will be any problem?
 
H

HerrVonStieren

New member
Jul 13, 2008
1
0
GT-N8010 not responding.

Hi!

My friend gave to me his Samsung Galaxy Note 10.1 (N8010), since it was stuck on some kind of boot-loop. I could access Odin-mode and Recovery-mode. Only thing about the recovery-mode was that it did display the droid with the spinning blue sphere in its belly. After some time, the tablet rebooted and was still stuck on loop. I tried installing Philz Touch via Odin and now it has stuck on "DOWNLOADING Do not turn off target!!" and I can only access Odin-mode (with the same message, not even displaying the warning and to push volume up to continue), If I try to go into recovery-mode, the screen goes haywire, showing the same "downloading..."-message and distorted screen. Even opened up the case and disconnected/connected the battery, nothing works. Any help?
 
D

Darkmo

Member
Aug 26, 2010
41
4
CWM recovery for N8000

Hi,

What is the last recovery CWM for Samsung Galaxy Note 10.1 (N8000) and where download it ?

Thank you
 
O

ordeniz

Senior Member
Oct 4, 2012
569
107
adipos said:
Hi there,
I have a Galaxy Note 10.1 N8005 (with sim card slot) bought from Turkey.Because this version has no phone function, I am wondering if I can flash with an European N8000 stock flash rom (I know this model has phone function).It will be any problem?
Click to expand...
Click to collapse

Gnabo kur dostum.Try Gnabo my friend.
 
N

nick.nguyen

Member
Oct 10, 2014
10
0
problem with up rom

Hi guys,
Please help me!
last time i used N8013 with revolution hd 10.1, till now i tried up new rom on xda but it's not working, its was hand up at samsung logo, and then i tried re setup CMR Download HighOnAndroid v1 ClockworkMod Recovery 6.0.1.1 and then re up rom revolution again, but it till stop at samsung logo, then i find one rom stock on samfirmware KIES_HOME_N8013UEALI3_N8013XARALI3_1081475_REV00_u ser_low_ship.tar but its has a problem ( factory mode has unabale working) and auto turn off wifi, so i dont know how to turn back my best tab before.
Please help me.
 
G

guihahn10

New member
May 24, 2015
1
0
I couldn't make it.

It stopped working last week and when I try to turn it on, just the message: "Samsung Galaxy Note 10.1" on a black screen.
I followed all the steps, but my GT-N8000 isn't getting the Recovery Mode Screen. When I Hold Power+Volume up button until get the Recovery mode screen, the screen just turn off and then turn on again on that messsage: "Samsung Galaxy Note 10.1" on a black screen.

What can I do to open the Recovery Mode Screen?


txtmikhail said:
Custom Rom Flashing Guide... (Not Stock)

1. Download the odin, Samsung drivers, root files and cmw files from above

2. Install the odin and samsungs drivers.

3. Plug your tablet into the computer and place the root zip on to your memory card..

4. Also found the Rom u want to install that works with your device and save it to your memory card

5. Once finished unplug your tablet from the computer and open odin on the computer

6. Power down your tablet.. Now Power it back on by Holding Power+Volume down button until you get the download mode screen

7. Plug your tablet back up to the computer (odin should see your tablet)

8. Using odin uncheck auto reboot and place the cwm tar in to the PDA box

9. Hit start button and let the process run

10. Once it finished Restart your tablet by Holding Power+Volume up button until you get the Recovery mode screen

11. Now install zip from sd card..

12a. Install su zip if u only want to Root your device

12b. Install Rom than su zip if u want a New Rom

13. Reboot device
Click to expand...
Click to collapse
 
FlaTEriC18041983

FlaTEriC18041983

Senior Member
Feb 23, 2008
206
1
41
Luxembourg
Hi, is the procedure cited two posts earlier also correct when I still have stock 4.4.2? Do I only need to flash twrp through odin, and after that the chosen ROM, e.g. the CM13?
thx for clarifying
 
Last edited:
You must log in or register to reply here.

Similar threads

GalaxyBill
.face Folder Is Choking With Thousands Of Files...
Replies
22
Views
219K
1
1AK907
B
[Q] Windows installing on Note 10.1
Replies
31
Views
52K
F
forrestwllms
K
[Q] Note 10.1 Boot Loop. Can't access recovery mode
Replies
66
Views
115K
J
JJEgan
E
GT-N8010 - Firmware Upgrade
Replies
8
Views
25K
J
JJEgan
A
GT-N8000 Firmware upgrade issue
Replies
12
Views
19K
Z
zakiyy

Top Liked Posts

24 Hours All time
  • There are no posts matching your filters.
  • 28
    samir_a
    samir_a
    Rooting & Installing CWM Recovery

    Rooting

    Method 1

    The easiest way of rooting is by downloading and installing the exynos from here

    http://xdaforums.com/showthread.php?t=2050297

    Install the APK on your device

    Run the APK

    2013_01_04_00_37_03.jpg


    Click on Root Device

    Your device is Rooted

    ---------------------------------------------------------------------------------------------------------------------------------------------------------------------------

    Method Two

    You will need the following things before you install the firmware

    CWM for Note - Attached DO NOT EXTRACT(Have not tried this particular one on any other version except N8000)

    Odin - Download for here http://androidfirms.in/tools.html

    SuperSU - Attached
    Copy SuperSU to SD Card (Internal or External)

    Note drivers - Should be installed with Kies (Make sure you exit kies before proceeding further)


    notevolpow.jpg


    Please enter Download mode on your tablet by pressing Power+Volume down button until you get the download mode screen as show below

    howto_root_galaxynote101_3_690x361.jpg


    Once you enter download mode this what you should see on the tablet please press volume up and ignore the warning

    Connect your device to your computer using the USB cable
    Make Sure your device is sufficiently charged
    Make sure all drivers are install correctly
    Exit Kies

    Extract all the file in the Odin archive if they are zipped

    Run_Odin.jpg


    Run Odin by clicking on the exe file as show above


    odin.jpg


    If all drivers are correctly install it should be detected by Odin in ID Com

    Click on PDA it will open file select menu and select the .tar file (CWM file attached should have extention .tar) by going to the location from where you saved it.

    cwm.jpg


    Make Sure you un-check Auto Reboot button in Odin


    Once the file is loaded, press the start button.

    Once the process in completed it show PASS but device will not restart.

    Do not restart the device in normal mode but in recovery Mode

    Press Power+Volume UP button till you see the GT-N8000 logo then leave power button but do not release the volume up button until it boots into recovery mode thats CWM

    Scroll down to Install zip from SDcard

    Select SD card if supersu is stored on the internal SD card or external SD if supersu is stored on external card

    Once you select it will give a warning message, select yes to proceed installing super su

    Once you are done you can go back to main menu and reboot (It may give you message which will disable device from installing stock recovery after you reboot select yes)

    Reboot device.

    Run SuperSu from applications

    Congratulations you have done installing CWM recovery and rooting your device!!!!!!

    Warning - Installing CWM will increase your binary count (Next tutorial will teach you how to reset it)

    Method 3

    Download CF Autroot from the following links

    N8000 - http://download.chainfire.eu/236/CF-Root/CF-Auto-Root/CF-Auto-Root-p4noterf-p4noterfxx-gtn8000.zip
    N8010 - http://download.chainfire.eu/247/CF...to-Root-p4notewifiww-p4notewifixx-gtn8010.zip

    Extract the files
    Run ODIN
    Put your device in download mode
    Load the .tar.md5 in PDF
    and follow the rest of the process you would follow for installing a rom
    View
    26
    samir_a
    samir_a
    Odin

    WARNING - When you downgrade from JB to ICS most probably you will get stuck at the Samsung Logo and your device will not boot, You will need to go into recovery and do a complete wipe & reset to boot
    So always backup your data before flashing a Rom


    You will need the following things before you install the firmware

    Firmware - you can download either from Samfirmware or http://xdaforums.com/showthread.php?t=2016792

    Once you download the files you will need to extract, the extracted file should have the following extention .tar.md5 remember the path where you extract the file

    Odin - you can download again from the above link

    Note drivers - Should be installed with Kies (Make sure you exit kies before proceeding further)


    notevolpow.jpg


    Please enter Download mode on your tablet by pressing Power+Volume down button until you get the download mode screen as show below

    howto_root_galaxynote101_3_690x361.jpg


    Once you enter download mode this what you should see on the tablet please press volume up and ignore the warning

    Connect your device to your computer using the USB cable
    Make Sure your device is sufficiently charged
    Make sure all drivers are install correctly
    Exit Kies

    Extract all the file in the Odin archive if they are zipped

    Run_Odin.jpg


    Run Odin by clicking on the exe file as show above


    odin.jpg


    If all drivers are correctly install it should be detected by Odin in ID Com

    Click on PDA it will open file select menu and select the .tar.md5 file by going to the location from where you extracted it.

    Once the file is loaded, press the start button.

    Odin will start the process of flashing the firmware and will take around ten minutes to complete it once it is successful it will show a pass message and reboot the device.

    You are done installing the new rom Congratulations !!!!!!!!
    View
    25
    samir_a
    samir_a
    This is the most common question asked on this forum how to install firmware using ODIN, I know there are many post in which this has been shown but I have decided to include this as a sticky thread so its up there for everyone to make use of.

    Initially this will only show installing firmware using Odin, other things will be added

    Post 1 - Introduction
    Post 2 - Installing Firmware using ODIN
    Post 4 - Rooting & Installing CWM

    The process of Installing the Firmware is the same for all variants of Note i.e 8000, 8005, 8010, 8013, 8020 BUT MAKE SURE YOU DOWNLOAD THE CORRECT ROM FOR THE VERSION OF NOTE YOU HAVE

    You can also flash Rom by copying the Rom on your device and using Mobile Odin Pro App
    The same is a paid app and is available of play store
    You need to be Rooted to use this app
    Link to Mobile Odin - https://play.google.com/store/apps/...xLDEsImV1LmNoYWluZmlyZS5tb2JpbGVvZGluLnBybyJd
    View
    2
    samir_a
    samir_a
    Everything except Method 1
    View
    2
    samir_a
    samir_a
    Please do not missguide them please tell me how can you flash a stock firmware using CWM recovery.

    IF YOU ARE FLASH STOCK FIRMWARE WHICH IS UNTOUCHED IT CAN ONLY BE FLASHED USING ODIN OR MOBILE ODIN CANNOT AND I REPEAT CANNOT BE FLASHED USING CWM
    View

New posts