I made charging cradle myself from polystyrene and old usb cable for sony ericsson, and I can charge my tablet with the poetic case on :good:
No need of 3D printer
Now looking at it, I realized I had to extend the pins from the cable with those little 'pins', using classic "soldering iron?" ( not sure about this word, I had to google it :laugh: ) because the pins of the tablet in the case were to high, then I thaught at first
Now looking at it, I realized I had to extend the pins from the cable with those little 'pins', using classic "soldering iron?" ( not sure about this word, I had to google it :laugh: ) because the pins of the tablet in the case were to high, then I thaught at first
And the whole 'body' is just covered with tesa tape - dont want to have polystyrene everywhere :laugh: