Great job bro. Now waiting for 32gb confirmation.
Sent from my LG-D802 using Tapatalk
Working on it
Great job bro. Now waiting for 32gb confirmation.
Sent from my LG-D802 using Tapatalk
Yeah big big thx for the instructions.Now i have LG G2 4.4.2 with root. One question,can i install xposed framework?
Gesendet von meinem LG-D802 mit Tapatalk
D802KK32GB.zip
Can somebody test this 32GB version ,and let me know if it works ?
In the OP you must change the file in step 1 , and flash this JB 32GB version from vodafone
http://lg-phone-firmware.com/tool.php?idclick=8811
Greetings , Kuoi
I have install on my 32gb Device and working fine with Post 1 Files. After all flashing i have 24,80gb free.
So you didn't need to use the new 32gb version?
Sent from my LG-D802 using xda app-developers app
D802KK32GB.zip
Can somebody test this 32GB version ,and let me know if it works ?
In the OP you must change the file in step 1 , and flash this JB 32GB version from vodafone
http://lg-phone-firmware.com/tool.php?idclick=8811
Greetings , Kuoi
does LTE works for you guys ? my carrier use 1800 & 2600 MHZ for LTE
Hi , i can CONFIRM : i did not have use the 32gb File. All files from Post 1 working fine here. Now running KITKAT 4.4.2 with root . :laugh: :good:
What kind of Vodafone bloatware or Vodafone brandings are included?
What kind of Vodafone bloatware or Vodafone brandings are included?
A little Vodafone Updates, which you can freeze.... :good: . Thats ALL.
----------------NO touch screen issues here !
Xposed NOT working , because xposed needs to update for the official KK roms
It seems to be confirmed that you can start with ANY rom as far as you have custom recovery installed , so start with a 4.2 rom is good to go !If you have NO SIM icon , just proceed with the steps , you will get your sim connection back on the KK rom
Use FlashTool (Download from here : http://xdaforums.com/showthread.php?t=2432476 Follow the instructions given in that thread1 : Flash the JB firmware from vodafone http://lg-phone-firmware.com/tool.php?idclick=8809 to get back to JB rom (needed to get root and recovery)
)2) Download LG mobile support tool and Install it. (It will open up when its done just CLOSE IT OFF)
LG Mobile Support Tool Download
3) Download / Install FlashTool (R&D Test Tool) & Drivers
Download Here
4) Power off your G2, press Volume Up & and then plug in the usb cable (enter to a download mode)
5) Extract FlashTool and run UpTestEX.exe
6) In R&D Test Tool window,
Select Type = 3GQCT (top left hand side)
PhoneMode = DIAG (top right hand side)
Select kdz file = click to select your LG stock rom *.kdz
Click "Normal web upgrade test" (bottom right hand side)
Then another window will pop up, click "Upgrade Start" button
wait a few seconds, another window "Select Country & Language" pop up,
=> Country=Republic of Korea
=> Language=English
you can click ok to proceed
7) All Done and wait for finish!
8) Be Sure that after flashing to perform a reset as for some reason flashing this does not remove what was there before until you reset. By turning off, Holding down power and Vol Down until it comes up on the screen.
. Make sure your USB debugging is ON (turn it on in the developers option by tapping the software version 7 times in the About phone menu). Make sure your connection mode is set to charge only. Double click on the root.bat file to root. Took me a few times before the ioroot tool detected my phone too. Now your jb 4.2.2 should be rooted.
INSTALLATION (Recommended)
1) Make a folder for the CWM Recovery.
2) Extract the contents of the file you downloaded earlier to the folder you just created.
3) Ensure the you have Developer Options enabled.
4) If you already have Debugging Mode enabled turn it off, then back on.
5) Connect your phone and ensure that the RSA Fingerprint message appears, and that you accept.
NOTE: THIS IS THE MOST IMPORTANT STEP! If you do not get this message and try to continue, you will not be able to install CWM recovery!
6) Open the CWM Recovery folder and double-click the file ends in "...recovery.bat".
7) A command prompt will appear and will go through a process flashing recovery to your phone.
8) Wait a minute and the process should conclude. Press any key to make the prompt disappear.
9) This will cause your phone to reboot into the CWM Recovery!
SPECIAL NOTE: The RSA Fingerprint message can be hard to get at times. After I rooted, it was extremely difficult to make appear. If it helps anyone, I would connect my phone to to the PC, run "...recovery.bat". The command prompt would state it was starting the daemon and then would go no further. If I checked my phone (before disconnecting from the PC) the RSA Fingerprint message would be displayed. If you have checked to always allow your computer, then you will not get the RSA Fingerprint message, but the procedure should still work. This is also true of the official CWM recovery installation.
I will flash once home but is it possible to get lg stock boot animation not the vodafone one ? thks
I don't remember who was writing that QuickRemote and QuickTranslater were not working, but I do confirm they're both working fine.
Great job bro. Now waiting for 32gb confirmation.
Sent from my LG-D802 using Tapatalk