A Little help please...

Search This thread

LightArrow123

Member
Nov 16, 2010
17
0
So I bricked my device over a month ago. I installed a rom from the wrong version of the hox, it wasn't the at&t variant. Then for some reason, I decided to try to flash a ruu, it finished flashing but now my phone will only go into usb interface mode on devicemanager and qhusb_
 

Heisenberg

Retired Forum Moderator
Jun 29, 2011
27,180
18,633
Knocking on your door
OnePlus 9 Pro
You need a jtag repair, only way to save it if it's in QHSUSB_DLOAD mode. Should probably do some reading before attempting anything else on the device once it's fixed too, to save this from happening again. The threads in my signature would be a good place to start.

Sent from my Evita
 

redpoint73

Inactive Recognized Contributor
Oct 24, 2007
15,254
6,968
Were you s-on and SuperCID, and did you try to run a Jellybean RUU? If so, that is a known brick situation. QHSUSB_DLOAD means you have a true brick and need JTAG as timmaaa said.

If S-on and superCID (plus JB RUU) and you flashed a ROM for the ENDEAVORU, that is a lot of mistakes caused by lack of research and lack of care while modding the phone. Again, like timmaaa I recommend more reading and understanding before messing with this or any phone.