[ FEITENG H9500 ] Known issues and fixes
Ok.. i see many people on this forum asking questions about this device.. the truth is this device is designed very poorly and it even may arive at your hands defective / with some or with a lots of problems.. you can proceed by your very own responsibility. Take a look in the picture for pcb details
- to Fix about every problem you need to findout how to unscrew the back plastic case and be able to see its PCB (Printent circuit Board) - Its pretty easy, just remove the little screws and give a presure at the clips of the cover to be removed, don't use metal objects because you will scratch the plastic.
* WIFI / GPS very low signal
Let me begin with one problem that you have FOR SURE.. is the low wifi signal and gps.. this is due to a horible design of the antenna.. the antenna is not just horrible, but it is also causing a short circuit it self! which is the main reason why the signal is low. First you have to stop the short circuit from happning
How to fix it? Unscrew the back cover, at the top of the back cover under the flash you will see a white sticker, this is the antenna, you have to remove completely this white sticker because it can't be useful by any way. Remove every piece of it including the copper-yellow color from the inside (the place that makes the connection.
Now find a UTP cable and take a piece of a hard copper of it, remove the plastic and keep the copper wire clear, cut it and place it in the whole were previewsly was the white sticker.. you have to place it in this way so it can connect with the inside conntact with the back plastic is placed and screwed again on the phone.. there are 2 pins in that place.. the old antenna used both of this pins (that was causing short circuit) you have to use the left pin and leave the right pin completely empty.. so the right pin doesn't connect anywere, and the left pin is connected to your piece of copper wire.
Cut the copper at the same size of the top of your phone.. so you can place it horizontal ... but you can also try vertical, (use wifi analyze app from play store to see what fits better for you)
Now.. this is the same antenna for gps.. you have nothing else to do.. just install GPS Test app and go outside and test your gps..
This is what i did and im pretty happy with it, instead i used 2 pices of copper and i covered the whole top place of my phone under the camera.. but that doesn't mean is the most right way because when we dealing with antennas there are a lot of math / and calculations that have to be done to design a perfect antenna.
the wire gives really a great signal.. just in case you want to reach the extreme.. Instead of copper wire you can use thin-Copper paper. (don't
use foil of aluminium is not good) and design a better antenna copying the design of an antenna from another phone (that you know it works)
* Camera autofocus doesn't work - Or camera doesn't work at all
[Don't unscrew] Frist thing you should try is remove the back cover and give a presure in the right side of your camera with your finger.. this is the place the connector is located.. and it may gets unclipped and loose the connection after a small drop or something. After that Reboot the phone.
[unscrew back] If this presure on the right doesn't fix it, then you have to unscrew the phone.. take off the camera and give it some small hits and punches.. place back the camera and see if it works.. this is due the autofocus motor got stuck.
* Mic, Speaker, USB doesn't work
[Don't unscrew] This is due the connector of the bottom part got lost its connection. remove the back cover and give presure under the place of the SIM cards, were it writes 'WCDM' and 'GSP'. press a bit those spots. reboot, if not fixed:
[unscrew back] The two bottom connectors is 1. for the touchscreen and 2 for the bottom parts.. you need to check both of those because i am not sure which is which.
* SIM1, SIM2, Microsd not working
[Don't unscrew] Try to give some press next to vol+ / vol- buttons
[unscrew back] On the top left of the PCB there are located 2 connectors, 1 is for the front camera, and 2 is for the SIM/SD parts.. the last connector to the side of vol buttons is the connector you have to check and press to make sure is connected ok.
* Touchscreen doesn't work
[Don't unscrew] Give presure right under the headphones jack
[unscrew back] This is were it is located.
CWM Recovery is like a Porn scene [ Do you want to wipe?: No, No, No, Noooo, Nooooooo, ah Noooooo YEEEEEESSSSSS NOOOOOOOO ]