Hi All,
I was out a couple of days back and my battery died. No trouble, come back home and charge it up. Worth noting that in recent months battery performance has been poor with a full charge only lasting about 8hours or so. I put this down to a new ROM I flashed as well as natural deterioration (18 month old S3).
Plug into the wall, red charging LED comes on, but the battery splash screen does not. Tried another charger...same. Thinking nothing of it I go to bed and wake up next morning to be greeted by a green charging LED. However, still no battery splash screen. I try to boot...it doesn't. When I "power on" the bottom LED buttons do light up white and go off after a few seconds. When I press the hold button again, they also come on for a few seconds. If i press the hold button while the button LEDs are on, they go off.
This makes me think the screen has broken as both the hold button and the charging LED is doing what it would do...but without any screen activity. However, it was not dropped or put under any pressure in any way. I have opened it up and also made sure the ribbon is undamaged and connected properly. I have tried calling the phone to no avail. It also does not vibrate or make any noises. Perhaps the battery doesn't have enough juice? Its as if its on the battery splash screen, I just cant see it.
I should mention the screen is infact cracked from an incident about 6-8 months ago. It was however, fully functional. Presumably, this will unfortunately stop me from sending it in. It was also using a flashed rom (CM11) and a flashed kernal (Boeffla).
I used a multimeter and measured 3.96v across the battery so that's fine. I can't test the current as I cant break into the S3 circuit and I dont have a resistor on hand to put some load on it.
Next steps?
I was out a couple of days back and my battery died. No trouble, come back home and charge it up. Worth noting that in recent months battery performance has been poor with a full charge only lasting about 8hours or so. I put this down to a new ROM I flashed as well as natural deterioration (18 month old S3).
Plug into the wall, red charging LED comes on, but the battery splash screen does not. Tried another charger...same. Thinking nothing of it I go to bed and wake up next morning to be greeted by a green charging LED. However, still no battery splash screen. I try to boot...it doesn't. When I "power on" the bottom LED buttons do light up white and go off after a few seconds. When I press the hold button again, they also come on for a few seconds. If i press the hold button while the button LEDs are on, they go off.
This makes me think the screen has broken as both the hold button and the charging LED is doing what it would do...but without any screen activity. However, it was not dropped or put under any pressure in any way. I have opened it up and also made sure the ribbon is undamaged and connected properly. I have tried calling the phone to no avail. It also does not vibrate or make any noises. Perhaps the battery doesn't have enough juice? Its as if its on the battery splash screen, I just cant see it.
I should mention the screen is infact cracked from an incident about 6-8 months ago. It was however, fully functional. Presumably, this will unfortunately stop me from sending it in. It was also using a flashed rom (CM11) and a flashed kernal (Boeffla).
I used a multimeter and measured 3.96v across the battery so that's fine. I can't test the current as I cant break into the S3 circuit and I dont have a resistor on hand to put some load on it.
Next steps?