Any way to enable fast charge on this kernel?

Is this kernel will be compatible with xtremeperia z? : )

What app r u using to set kernel settings ?
I tried using set cpu and ROM toolbox but it doesn't seem like it sticks.

Please any suggestions ?

Sent from my SGH-T999 using xda app-developers app

Originally Posted by bstylz911

What app r u using to set kernel settings ?
I tried using set cpu and ROM toolbox but it doesn't seem like it sticks.

Please any suggestions ?

Sent from my SGH-T999 using xda app-developers app

Try trickster mod

Sent from my SGH-T999 using xda premium

I Pray this Fix My Problem

---

Originally Posted by akapaul26

I was one on the thread bitching about settings. FYI I figured out what works for me, I hope this might help others. You must start fresh. I formatted everything, sd, internal and odin back stock. I dont think all this is necessary but its what I did just to start clean. I would suggest this tho....

Wipe your cache dalvik and factory reset. Then install your rom. Once you install rom let it sit and reboot. Once your device has turned back on reboot again into recovery, dont set anything up. Now wipe cache and dalvik then install kernel and reboot. Run through setup, allow for your device to restore apps and build system. Now choose an app to adjust your kernel settings, I suggest setcpu. Set your settings, I use smartass v2 min 384 max 1728 cfq scheduler, no profiles, make sure to check set on boot. At this point reboot. Once you are running again go into set cpu and check your settings. Mine didnt stick the very first reboot, if they didnt reset them again. You should be good to go now.

I think the key for me was installing a fresh rom and the kernel directly after. Then set up device. Once you let it settle then you can restore your data and flash your themes. I have had no problem doing it like this and have tested it on two roms...trust me I was getting pissed cause I was one whose settings would not stick...I kinda took it upon myself to investigate. Hope this helps someone else as well.

Attachment 1699043Attachment 1699044Attachment 1699051

Domination V3 Powered!

I been running into this problem since yesterday i wiped everything and flashed this rom 3-5X and still my cpu settings wont stick. I was using Antutu cpu master and after setting my cpu i would back out. and click on the app again and it would be suck back to where it was(1046 min _ 15xx). I tried flashing the different Kernels in the Aroma installer and still same result. Im going to try Set cpu and see if this works

No Access

---

I can't download the kernel from your source.