How to replace vibration, microphone module

Hello there,

I don't know if it's a hardware problem in your case but I had the same problem and what I did was:

- Took the lower back cover out. (use a pry tool or just your fingernails but with caution...see first pic)

- Cleaned the hole which is supposed to be open for the mic using a needle. It was blocked by dirt/sand/spiderweb/one of my exes

- Put the whole thing back together and voila! Crystal clear sound.

If it is a hardware problem then you have to disassemble the phone to the lower board out. It is not glued but this ribbon cable runs all the way behind the battery, so as I said, you have to take the phone apart. Check out this video.

Probably you won't have to take the main board out, just the battery to free the lower board.

Report how it goes :good: