Here is my short story:
I lost my phone in the garden, after 3 days of searching and as the snow melted, i saw it lying on the ground, unfortunately turned off. Dont think this happend because of low battery rather than because of the water.
After i found it, i immediately dissassembled it without turning on and now its drying..i will wait for some days, until i can get some isopropanol(97% alcohol or so).
The water-indicator is lilac, not shure, but this means damaged by water, right?
So now here are my questions..is there even a chance that the isopropanol might help?..because the phone was turned on as i lost it, and i think it stopped working due to the water, not because of low battery..so is it already to late? Does this method only help if the phone is still working?
And which parts should be bathed in isopropanol ? E.g. is it bad for the camera, the microphones, the screen and the speakers, as i have read somewhere?
And if for example the screen would be damaged, would it be bad for the logicboard, too, if i reassemble it again and test it then?
And is there any possibility i can find out which part is defect, if it won´t work at all?
Are there any other options left for me?
hope this doesnt happen to anyone else
greets, electro
I lost my phone in the garden, after 3 days of searching and as the snow melted, i saw it lying on the ground, unfortunately turned off. Dont think this happend because of low battery rather than because of the water.
After i found it, i immediately dissassembled it without turning on and now its drying..i will wait for some days, until i can get some isopropanol(97% alcohol or so).
The water-indicator is lilac, not shure, but this means damaged by water, right?
So now here are my questions..is there even a chance that the isopropanol might help?..because the phone was turned on as i lost it, and i think it stopped working due to the water, not because of low battery..so is it already to late? Does this method only help if the phone is still working?
And which parts should be bathed in isopropanol ? E.g. is it bad for the camera, the microphones, the screen and the speakers, as i have read somewhere?
And if for example the screen would be damaged, would it be bad for the logicboard, too, if i reassemble it again and test it then?
And is there any possibility i can find out which part is defect, if it won´t work at all?
Are there any other options left for me?
hope this doesnt happen to anyone else
greets, electro