Touch Screen Calibration Messed Up After Flashing ROM on Wrong Firmware
I'll try to remember the steps of what happened as best I can.
T989 All Stock Running Gingerbread (Not sure what Firmware)
1)Installed CWM via ODIN
2)nstalled SuperUser via CWM
3)Installed latest AOKP from here http://aokp.co/devices/hercules
Booted up just fine but two problems
1: No Service
2: Touch screen calibration was WAY OFF
BYAM DURP OOPS
Realized that I needed to get the latest Firmware before flashing the latest AOKP!
4)Full Wipe(I think?)
5)Install latest Firmware (T989UVMC6, right?) (Also did a factory reset/wipe)
Phone boots into Stock with latest firmware, however the touch screen is still calibrated way off!
Do steps 1-3 above again.
Touch screen calibration is still way off!
My only guess on the reason/fix for this is that maybe this is still some lingering problem of flashing the ROM on the outdated firmware, so I need to perform some sort of deeper wipe than just a Full Wipe via ClockWorkMod in order to get rid of any lingering problems. And then flash the latest firmware, and do steps 1-3 above.
Any ideas or suggestions?
Any other information needed?
Thanks in advance!