[Q] Gnex port to page plus - looking for help on getting data to work
Thank you for the great info on getting the galaxy nexus over to page plus.
I've followed dragonhart's youtube video, a blog post based on that
and gone through some of the original threads referenced in the discussions
I probably hit half of the snags mentioned in those articles but have overcome most so far. The one i'm stumped on is the ETS script to program the via chipset.
When running the script after putting in the appropriate values, I get the following error:
ETS, Id=CP Fault, Unit=HLW... Code 1=HLP_ERR_ACTIVE_PARM_PROFILE_ID, Code 2=0x00000001, Fault Type=Continue
Stepping through the code, this occurs on the line (approx) 106, where the active profile id is set:
ETS, Id=CP Active Profile ID Set, ParmOperationId=Profile Id of Active Profile Set, opType=Parm Custom Value, ActiveProfile=0
The script finishes, installing back to VZW Toro rom and placing simcard results in talk and text but no data.
If I change the ActiveProfile to 1 instead of 0, the script finishes with no errors but installing VZW Toro rom + sim card still results in talk and text but no data.
I also tried modifying the line below to set the number of profiles set parameter to 2 instead of 1 (I just took a wild guess that since I was using profile id 1, I needed to change it). It had no effect.
Next, i thought maybe my sim card was bad so I ordered a new one. Still no go.
I've reinstalled the via drivers and ets multiple times and gone through the process multiple times after restoring factory settings with *#*#786#*#* each time.
SID, IMEI, MIN, MDN are all verified and correct.
Does anyone have any good suggestions on what I am doing wrong?
Thanks a ton for all the helpful posts on the forums so far. I've been learning alot.