[GUIDE] Flash Official JB 4.1.2 Firmware on P6810 Wi-Fi Device
Sick and tired of Samsung ignoring the official JB 4.1.2 update for our much maligned and forgotten device?
Well, you’re in luck, this guide will effectively turn your P6800 Wi-Fi device into a P6800-GSM/3G model. We do this by changing the device partition layout and then flashing P6800 firmware with Odin.
Of course, due to hardware differences, you won’t have a working radio/modem. Also, some unneeded system apk's will need to be removed and the UI will also need some cosmetic changes etc, but it's a start.
WARNING & DISCLAIMER: I am not responsible, YOU are! You can probably forget about your warranty. This will wipe everything and increase your flash counter too !
PRE-FLASH REQUIREMENTS
1. Internal sdcard contents backed up off device
2. Any apps & data (is you wish) backed up off device
DOWNLOAD REQUIREMENTS
1. P6810 Wi-Fi model with a FULL battery
2. Windows PC
3.
P6800_3G_16G.pit
4. Download P6800 JB 4.1.2 DXMD3 firmware from:
5.
Odin 3.07
6.
Samsung drivers
METHOD
1. Extract P6800_3G_16G.pit & P6800 firmware so you just have
.pit &
.tar files
2. Drivers
a) Uninstall or disable KIES
b) Install Samsung drivers & reboot PC
3. Run Odin 3.07 & install
[PIT] = P6800_3G_16G.pit
[PDA] = P6800 official JB 4.1.2 firmware .tar file
4. Download Mode
a) Power off device
b) Hold volume down + Power
c) Release buttons at Warning Menu
d) Volume up to continue
5. Connect device to PC via USB cable
6. ID:COM should change colour in Odin 3.07
7. Click [START] and watch the magic
8. If you get a screen message with button [Reset perangkat] (Reset device), just tap it
NEW PARTITION LAYOUT
FURTHER RECOMMENDATIONS
MY P6810 RUNNING EROBOT ROM + SKYHIGH KERNEL
GUIDE: DOWNGRADE P6810 (WIFI) FROM OFFICIAL JB 4.1.2 TO ICS 4.0.4 IN POST #2
.