N7105 *#9090# default and LTE/4G question
Need some assistance regarding a setting for the N7105. If someone could kindly input in their dialer *#9090# and tell me what the default settings are (please do not select anything). Then press back button to cancel.
The default settings are the ones with an asterisk in between two brackets, as seen here (*)
I accidentally selected
when checking out the service mode/diag config using the above dialer code.
On another matter, also in regards to the N7105. Has anyone noticed in Settings>About Device>Status, that their N7105's Mobile network type is consistently LTE:14
Reason being, is that when my phone is displaying that status, my signal bar shows only 1 bar. However, it does sometimes show full bars and the Mobile network type then displays 'UMTS:3'
I am in an area that can receive 4G signals (Sydney, Australia), but I was under the impression that my phone should be idle in UMTS:3 mode for general calls and SMS; and switching to LTE:14 when I activate mobile data and thus use 4G signal.
I am able to make calls/sms and connect to 4G with no problems, however am concerned that since it tends to be in LTE:14 mode the most that it may drain the battery more than if it were in UMTS:3
Thanks in advance.
Note II (N7105) - BeanStalk 4.3. RC1.1 + W03Tweaks v1.6.1 - N.E.A.K Kernel v2.2